SOCKET-PLUG 6V0092 - Caterpillar

Illustration 1 g02436560
484 Transfer Case - 369-8897 Transfer Gear Gp (V) Magnetic plug / oil drain port (2) Differential / Lockup piston (3) Pneumatic (air) line connection (4) Air defuser (5) Threaded hole used for assembly (6) Detent switch - The detent switch is hidden behind callout (63) in this view. The detent switch detects when transfer case is in neutral and sends signal to ECM. (56) Access plate (57) Serial number plate (58) Breather (59) Mounting holes - (M16 - 2) (60) Lube line (60 psi) (61) Ball switch (indicates shifting status) (62) Shifting piston (default to high 1:1) (high 1:1, neutral, low =3.0882:1) (63) Customer interface connector (Wire harness receptacle) (64) Pneumatic line (Neutral) (65) Lube line (0.41340 MPa (60 psi)) (66) Rear output yoke (67) Mount for stabilizer bar (68) Lube line (69) Pneumatic line (shifting piston for low gear (70) Pneumatic line (lock and unlock differential) (71) Low gear solenoid (72) Differential lock solenoid (73) Neutral solenoid (74) Oil inlet from pump (pump on CX28 PTO) (75) Oil temperature sensor (76) Output speed sensor (77) Lifting eye - 5/8 - 11
Illustration 2 g02625178
(78) Washer (79) Retaining ring (80) Ball bearing (81) Bearing carrier (82) Shim pack (83) Roller bearing cup (84) Roller bearing cone (85) Input gear (86) Tapered cup (87) Collar (88) Carrier assembly (89) Ring gear (90) Wave spring (91) Cover (92) Ball bearing (93) Seal carrier (94) Sun gear (95) Shim pack (96) Roller bearing cup (97) Seal carrier (98) Temperature sensor (99) Planet gear (100) #4 orificed o-ring to #4 JIC (101) Output Yoke (102) Rear output shaft (103) Self locking 1 1/4 - 12 nut (104) Washer (105) Output cover (106) Roller bearing cone (107) Roller bearing cup (108) Shim pack (109) Nut (110) Tapered roller cup (111) Bearing cone (112) Sun gear (113) Gear assembly (114) Fork (115) Collar (116) Roller bearing cup (117) Roller bearing cone (118) Forward output shaft (119) Main housing (120) Idler gear (121) Key (122) Shaft (123) Roller bearing cup (124) Self locking 1 1/4 - 12 nut (125) Input shaft
Illustration 3 g02646757
(126) Input yoke (127) Lip type seal (128) Sleeve
Illustration 4 g02638360
(85) Input gear (113) Gear assembly (120) Idler gear (125) Input shaft (129) Spring (130) Strainer assemblyTorque from the transmission output, which is attached to the input shaft (125) via a short coupling, drives the input shaft to rotate. The input shaft is splined to the sun gear (94). In HIGH, the sun gear (94) is splined to the input gear (85) by the collar (87). In LOW, the sun gear (94), is splined to the carrier (88) by the collar (87). The gear carrier assembly (88) drives the input gear (85). The speed ratio between the input shaft (125) and input gear (85) in HIGH is 1:1, and the speed ratio in LOW is 3.0882:1. The collar (87), may be positioned so that neither the gear carrier assembly (88) or the input gear (85) are engaged and the transfer gear is in NEUTRAL.The input