SOCKET 8S1598 - Caterpillar

Parameter Descriptions
"Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Engine Serial Number"
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."FLS" (Full Load Setting)
"FLS" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or a new ECM is installed. Factory passwords are required."FTS" (Full Torque Setting)
"FTS" is similar to "FLS". Only change this value if the engine is rerated or a new ECM is installed. Factory passwords are required."Idle Quality Adjustment"
The "Idle Quality Adjustment" allows the user to optimize idle stability. Each number between −4 and 4 corresponds to a set of fuel maps."Engine Security System Status"
The "Engine Security System Status" will inform the user if the system has been installed and if the system has been enabled. If the ECM does not detect the security system, the status will be "Unavailable". Once the ECM detects the security system on the data link, the parameter is changed to "Enabled". The user can disable this parameter with factory passwords.System Configuration Parameters
Table 1
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
ECM Identification Parameters    
"Equipment ID"     Unprogrammed Software     Blank     None    
"Engine Serial Number"     0XX00000
or
XXX00000     Blank     None    
System Parameters    
"Full Load Setting (FLS)"     Factory Calibration     Factory    
"Full Torque Setting (FTS)"     Factory Calibration     Factory    
Selected Engine Rating    
"Idle Quality Adjustment"     -4 to 4     0     None    
"Engine Security System Status"     "Unavailable"
"Enabled"
"Disabled"     "Unavailable"     Factory    Parameters Worksheet
Note: A mistake in recording this information will result in incorrect passwords.
Table 2
Engine Parameters    
"Equipment ID"    
   
"Engine Serial Number"    
   
"ECM Serial Number"    
   
"Personality Module Part Number"    
   
"Personality Module Description"    
   
"Personality Module Release Date"    
   
"FLS"    
   
"FTS"    
   
"Rated Power"    
   
"Rated Peak Torque"    
   
"Top Engine Speed Range"    
   
"Test Spec"    
   
"Total Tattletale"    
   
"Engine Security System Status"    
   
Table 3
Information from Engine Information Plate    
"Engine Serial Number"        
"FTS"        
"FLS"        Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Only change the FLS and the FTS because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.