SOCKET 9X3042 - Caterpillar

Alternative Removal Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
E(1) 177-8001 Sleeve 1
F 177-8002 Adapter 1
G 6L-4697 Bolts 3
(1) Part of 177-8003 Engine Tool GroupStart By:
Remove the camshaft gear. Refer to Disassembly and Assembly, "Camshaft Gear - Remove and Install".
Remove the rocker arms and the rocker shafts. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Remove". Note: This is an optional procedure to remove the camshaft. The preceding tool list shows the required tooling for removing the camshaft from the front of the engine or the rear of the engine.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not turn the crankshaft or the camshaft while the camshaft gear is removed. If the front gear group is not correctly timed during installation, interference can occur between the pistons and the valves, resulting in damage to the engine.
Illustration 9 g01056681
Remove bolts (2) and thrust plate (1).
Illustration 10 g01071487
Remove sealing plate (3) from the front housing. Remove adapter assembly (4) from the crankshaft.
Illustration 11 g01056684
Remove O-ring seals (5) and (6) from sealing plate (3).
Illustration 12 g01056675
Remove flat head screws (9) and cover (10). Remove the O-ring seal from the cover.
Care must be used when removing or installing the camshaft. Do not damage the finshed surfaces of the camshaft or the camshaft bearings.
To remove the camshaft from the rear of the engine, go to Step 6 through Step 9. To remove the camshaft from the front of the engine, go to Step 10 through Step 13.
Illustration 13 g01056714
Removal of the camshaft from the rear of the engine
To remove the camshaft from the rear of the engine, install Tooling (F) on the front of camshaft (8) with Tooling (G). Note: Carefully align Tooling (F) with the end of camshaft (8). If the adapter and the camshaft are not aligned, the camshaft may not be removed. The adapter and camshaft bearing will interfere.
Install Tooling (E) on Tooling (F).
Carefully slide the camshaft to the rear of the engine for removal. Use two technicians to remove the camshaft. Keep the camshaft level while the camshaft is being removed from the cylinder head. The weight of the camshaft is approximately