SOFTWARE GP- 3156696 - Caterpillar

Feeder Control Paddle
Illustration 1 g00588441
There are two feeder control paddles. There is one paddle on each side of the machine. The feeder control paddles provide feedback to the electronic control module. The mix height control provides the operational input of the height of material that is desired.The feeder control paddles should be mounted within 1 foot of the auger. The angle of the feeder control paddle determines the speed of the drag conveyor and the auger conveyor. The operating range of the feeder control paddle is zero degrees to 45 degrees. Adjust the length of the paddle in order to gain additional material height. Decrease the length of the paddle in order to increase the material height.Sonic Sensor
Illustration 2 g01730213
The sonic sensors for the auger can be adjusted to different positions in relation to the machine side plate and the screed end gate. Install the sonic sensor for the auger (1) and use mounting hardware (2) in order to position the sonic sensor for the auger. Adjust the sensor in order to prevent material from contacting the sensor. Adjust the sensor in order to prevent contact with the machine side plate during operation.