SOFTWARE GP- 3484733 - Caterpillar

Table 4
Required Parts for 16M 370-8400 Cylinder Guard Gp    
Item     Qty     Part Number     Description    
1     2     9C-5344     Spacer    
2     4     367-6790     Clamp As    
3     1     383-9793     Guard    
4     1     383-9794     Guard    
5     4     4I-7889     Spacer    
6     4     7X-2546     Bolt    
7     10     7X-7729     Washer    
8     4     8T-0389     Locknut    
9     2     8T-4186     Bolt    
10    
104 cm (41 inch)     7X-7877     Edging Strip    Rework Procedure
Ensure that the machine is properly parked for service. Refer to the Testing and Adjusting manual, "Machine Preparation for Troubleshooting".
Illustration 1 g02551613
Inspect hole (A) in the bottom of the head end clevis (B) of both steering cylinders. If necessary, use a tap to clean up the threads of bolt hole (A) .
Illustration 2 g02551942
Typical view of clamp for all models except 14M
Illustration 3 g02568357
Clamp for 14M
Install edging strip (10) to each of clamp (2). Each edging strip should be 130 10 mm (5 0.4 inch)
Illustration 4 g02552250
Remove existing bolt (C) and washer (D) from the flag of pin (E) on the steering cylinder.
Fit the corresponding cylinder guard over the steering cylinder. Refer to Table 1 through Table 4 for your guard for your specific model.
For the 16M loosely install bolt (C) and washer (D) through the bolt hole in the top of the guard and into the threaded hole from which bolt (C) was previously removed. No additional spacer or washer is used in this location. For the 120M through 160M AWD machines, loosely install one bolt (9) and one washer (7) in place of the bolt removed in Step 4. For the 14M and the 120M through 160M non-AWD machines, loosely install one bolt (9), one washer (7), and one spacer (1) in place of the bolt removed in Step 4.
Illustration 5 g02552266
(1) Spacer (7) Washer (9) Bolt (B) Clevis
Using one spacer (1), loosely install one bolt (9), and one washer (7) through the bolt hole in the bottom of the guard. The spacer should be installed between the guard and the bottom of the head end clevis (B) of the steering cylinder.Note: Install bolt (9) in hole inspected in step 2
Illustration 6 g02552268
Clamp for all models except 14M
Using two spacers (5), two bolts (6), four washers (7), and two locknuts (8), install two clamps (2) on guard.Note: For all models except 14M. For information regarding the 14M refer to Step 9.
Illustration 7 g02568559
Clamp for 14M
Using two spacers (5), two bolts (6), and two washers (12), install clamp (2) with u-bolt (11), two washers (7), and two locknuts (8) on guard.Note: Before tightening all bolts, be sure that there is no interference between any existing components or hoses and the guard.
Tighten all hardware.
Repeat Steps 2 through 10 in order to install the guard