SOFTWARE GP-ENGINE 5065828 - Caterpillar

PL321VSR Software Update Instruction and Configuration
Perform the below steps for PL321VSR software update instruction and configuration:
Connect "Comm Adapter 3" to the service port of the machine.
Using the Cat® Electronic Technician (Cat ET) Service Tool 2015C or newer, download the software for the VIMS A4N4 ECM to the software specified in Table 5.
Illustration 14 g06355756
Preferences Tab
Open Cat ET 2015C or newer, select "Utilities" -> "Preferences" -> "Modify" and set connection to "Caterpillar Comm Adapter 3 (RP1210)", defaults to "J1939 Baud Rate 250k" and select "OK". Refer to Illustration 14.
Illustration 15 g06355759
Click on "Winflash" icon.
Select the ECM labeled "VIMS A4:N4 Main" in the WinFlash ECM list and load the software. Follow software availability from SIS web "VIMS Software & Current Releases". Refer to Table 5 (VIMS Compatibility Software Matrix).
Once the download is complete, select "File", and select "Return to Cat ET", and select "VIMS Main Module", and then select "OK".
Illustration 16 g06355765
Configuration Screen
Select "Service" -> "Configuration Screen".
Illustration 17 g06355783
Select "VIMS Main Module" -> "General Information" -> "PLM Enable Status (Billing)". Refer to Illustration 17.Note: If the "PLM Enable Status (Billing)" is not seen in "General Information" as shown in Illustration 17, then select "File" -> "Switch Data Link".
Illustration 18 g06355815
Set the "PLM Enable Status (Billing)" configuration to "Disabled". Refer to Illustration 18.Note: This action effectively disables the 2G cellular radio in the PL121 satellite radio. Harness to the PL121 radio should remain connected to the PL121. If PL121 radio is not connected user will receive an active code 1250-9 Remote Communication Module: Abnormal Update Rate. With some installations, code 1250-9 Remote Communication Module: Abnormal Update Rate will be inactive if the PL121 is connected. 1250-9 Remote Communication Module: Abnormal Update Rate will only be visible with Cat ET. This code is not shown on operator display and does not limit functionality of the system. GPS and Satellite LED’s will continue to blink when machine is power cycled on. Green LED will be on solid only if R-Term is used and engine is running.
Illustration 19 g06355821
Within the Configuration screen, select "ECM Identification Parameters" -> "Product ID" enter the Product ID into the "VIMS Main Module" as shown in Illustration 19.VIMS Main Module A4:N4 Configuration File Upload
A configuration file is required for VIMS A4N4 ECM. Connect 305-5528 Wiring Harness (VIMS 3G service cable) to the VIMS Service Port.
To install the VIMS config file follow instructions outlined in Special Instruction, REHS7428, "VIMS 3G Software Installation Guide For Certain Cat® Product Using VIMSpc 2011A and VIMSpc 2013A".Instruction for PL542 Software Update
Connecting to the PL542 with Cat ET
With the PL542 connected to the service port on the machine, users are unable to connect to the PL542 with Cat ET without a "Y" harness. For machines with a standard 9-pin service port connector, use 140-9442 Adapter Cable As.
140-9442 Adapter Cable As allows the PL542, and Cat ET to be on the datalink at the same time.
The Product ID can