SOLENOID GP-SHUTOFF 1996157 - Caterpillar

Manual Operation
The power module can be used as a stand-alone unit to power an isolated load. Manual operation refers to manually closing the circuit breaker switch for the generator. The following information describes the steps for manual operation in the single unit mode.
Ensure that all load cable connections have been correctly made.
Verify that the unit can be safely started.
Verify that power can be applied to the load.Pre-startup Procedures
The pre-startup procedures are to be performed by qualified personnel. Perform the following steps before the unit is started.
(Optional) Turn the GPC and the UMR paralleling controls off.Note: If the paralleling controls are turned off, the operator can adjust the frequency manually. The power module operates like a standard generator set if the paralleling controls are turned off.
Install the "lead unit jumper". The lead unit jumper is connected between terminals 1UP-93 and 1UP-94 in the customer connection box. The jumper is required in order to allow the generator breaker to close in the single unit mode manual operation mode.
If the Cat DVR settings are unknown, then use the Caterpillar service tool to verify the configuration of the Cat DVR. The "load compensation mode" parameter is normally set to OFF.Startup Procedures
Press the "RUN" button that is on the EMCP 3 control.Note: The engine will begin to start immediately.
Use the EMCP 3 display to observe the generator voltage and the frequency once the engine is running at the rated speed.
Use the operator controls to adjust the voltage and/or the frequency if necessary.
Use the circuit breaker switch to close the generator breaker at the appropriate time. Rotate the handle clockwise until the breaker closes, then release the handle. After the handle is released, the generator unit will be providing power for 100 percent of the load.Shutdown Procedure
Press "STOP" button that is on the EMCP 3.Note: The generator breaker will open immediately. The engine will continue to run in cool down mode until the cool down time has elapsed. The engine will shut down after the cool down time has elapsed.Automatic Operation
The power module can be used as a stand-alone unit to power an isolated load. Automatic operation refers to the use of the on-board control system to close the generator breaker automatically. The following information describes the steps for automatic operation in single unit mode.
Ensure that all load cable connections have been correctly made.
Verify that the unit can be safely started.
Verify that power can be applied to the load.Pre-startup Procedures
The pre-startup procedures are to be performed by qualified personnel. Perform the following steps before the unit is started.
(Optional) Turn the GPC and the UMR paralleling controls off.Note: If the paralleling controls are turned off, the operator can adjust frequency manually. The power module operates like a standard generator set if the paralleling controls are turned off.
Install the "lead unit jumper". The lead unit jumper is connected between terminals 1UP-93 and 1UP-94 in the customer connection box. The jumper is required in order to allow the generator breaker to close in the single unit mode