SOLENOID AS-STARTING MOTOR 2381851 - Caterpillar

Press the Back button to return to the previous menu.Service Mode
Service > Service ModeNote: A password (pass code) is required to access expanded Configuration and Calibrations menus.Note: Service mode is deactivated when the machine is shut down.
Illustration 7 g03734082
Press the "Service Mode " button. A Service Mode page with a keypad will appear if Service Mode is disabled. A keypad will not appear if Service mode is already activated.
To enable "Service Mode" and access expanded Configuration and Calibration menus, enter a password (pass code numbers) on the keypad. Note: The default password is 1234.
Select "Enable".
Press the "OK" button.
Press the Back button to return to the previous menu. Service Mode Enabled
When Service Mode is "Enabled":
View expanded Configurations and Calibrations on the current Service Menu page
Adjust Configuration settings and perform Calibrations Service Mode Disabled
Illustration 8 g03734097
Service Mode Disable screen
When Service Mode is "Disabled":
A subset of Configurations and Calibrations will not appear on the Service Menu pageConfigurations
Service > Configurations
Press "Payload". "Payload" will highlight in blue and the Payload Configuration menu pages will appear.Payload Configurations
Service > Configurations > Payload
Illustration 9 g03734412
Service Configuration screen
Press "Configurations". "Configurations" will highlight in blue and the "Configurations" page will appear.
Illustration 10 g03734899
Configurations > Payload highlighted screen
Press "Payload". "Payload" will highlight in blue and the "Payload" Configuration menu pages will appear.
Illustration 11 g03734100
Payload Configuration screen 1
Illustration 12 g03734101
Payload Configuration screen 2
Available Configurations
Available configurations are:Printer Installation (Password Protected)Note: The Service Menu password must be entered in order to configure this parameter.
Illustration 13 g03735097
Printer Installation screen
The options in the Printer Installation screen are "Installed" or "Not Installed".
Illustration 14 g03735100
Auto Truck ID Configuration screen
The options in the Auto Truck ID Configuration screen are "Enabled" and "Disabled".
Illustration 15 g03735102
Auto Material ID Configuration screen
The options in the Auto Material ID Configuration screen are Enabled and Disabled. Configurations With Cat® Electronic Technician (Cat ET)
Payload Configuration
Overload Warnings
The overload warning feature notifies the operator when a payload measurement exceeds 116.5% of the Loader Bucket Payload Target Weight configured in Cat® Electronic Technician (Cat ET) . The feature can be enabled/disabled through Cat ET as well, and is disabled by default. If a calculated weight is overloaded, and the machine has gone to reverse since digging, the operator will be notified via a pop-up. This fault is also sent off board into VisionLink ® and logged on the machine. The system monitors for overload both in normal operating mode and in standby mode. (VisionLink is a trademark of Trimble Navigation Limited, registered in the United States and in other countries).Reference: For information on how to determine an appropriate overload limit see Payload Policy, AEXQ1391-00, "Cat Medium Wheel Loader Payload Policy - K Series, M Series". This media can be found on the Cat Media Information Center (CMIC) at https://cmic.cat.com/cda/files/4726317/7/AEXQ1391-00_update.pdf