AVSPARE.COM
parts catalog

SOLENOID 2712117 - Caterpillar


2712117 SOLENOID Caterpillar parts
Rating:
60
Alternative (cross code) number:
CA2712117
271-2117
2712117
Caterpillar 2712117 SOLENOID
Weight: 0.73 pounds 0 kg.

Buy SOLENOID 2712117 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
$741.00
 

29 Feb 2024

US: Empire Rigging
CROSBY Latch 3T-IPHGZ IP1233 (2712117)
Crosby
$719.00
 

12 Aug 2023

US: Empire Rigging
CROSBY Latch 3T-IPHGZ IP1233 (2712117)
Crosby
$540.00
 

23 Apr 2021

US: Empire Rigging
CROSBY Latch 3T-IPHGZ IP1233 (2712117)
Crosby
  For full view, you need register

Information:


Illustration 1 g01396375
Schematic of the Primary Steering Pressure SwitchCID 0793 FMI 03 diagnostic code can only be recorded if the optional secondary steering system is installed. The primary steering pressure switch is connected to two inputs of the ECM. One contact is open and the other contact is grounded during proper operation.The code FMI 03 means that the ECM has determined that both contacts are open.
Table 1
Primary Steering Pressure Switch    
Switch Position    417-GY Circuit
N/O
J2-37    484-YL Circuit
N/C
J2-38    
Low Pressure     Open     Closed    
High Pressure     Closed     Open    Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected.Note: Ensure that the diagnostic code indicator is active and that the diagnostic code is active.Test Step 1. CHECK THE GROUND CIRCUIT OF THE SWITCH IN THE HARNESS
Turn the starter keyswitch and the disconnect switch to the OFF position.
Disconnect the connectors of the transmission harness from the ECM.
Measure the resistance between contact A (wire 201-BK) and cab ground.Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The circuit is correct. Proceed to Test Step 2.
NOT OK - The resistance is greater than 5000 ohms. The circuit is open. The transmission harness has failed.Repair: Repair the transmission


Parts solenoid Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.