SOLENOID 3180462 - Caterpillar

Removal Procedure
Start By:
Remove the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00473474
Use a soft punch in order to remove piston cooling jet (1) from the cylinder block.Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     6V-7772     Driver     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The No. 2 and No. 6 bosses for the main bearings have two jets. The No. 3 and No. 5 bosses for the main bearings have one jet. A replacement is necessary only if the jets are damaged. Normally, it will only be necessary to ensure that the jets are clean.
Illustration 2 g00473474
Use Tool (A) in order to install piston cooling jet (1) with the small end first. Install the jets in the bosses for the main bearing until the jets are against the counterbore.
Ensure that the passage is open after piston cooling jet (1) is installed.End By: Install the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Install".