SOLENOID AS 3E6424 - Caterpillar

Connecting Rods And Pistons
Use the 7M-3978 Ring Expander to remove piston rings or install piston rings.Use the 5P-3526 Piston Ring Compressor to install pistons into the cylinder block.Tighten the connecting rod nuts in the step sequence that follows:
Apply 4C-5593 Anti-Seize Compound to the threads of the bolts and the contact surfaces of the bolt head.
Tighten all nuts to the following torque.Torque for nuts ... 82 8 N m (60 6 lb ft)
Put an alignment mark on each cap and bolt.
Tighten the nuts from the mark to the following value.Angle from the mark. ... 120 5 degreesConnecting Rod Bearings
The connecting rod bearings fit tightly in the bore in the rod. If the bearing joints or backs are fretted, check the bore size. This can be an indication of wear because of a loose fit.Connecting rod bearings are available with 0.63 mm (0.025 inch) and 1.27 mm (0.050 inch) smaller inside diameter than the original size bearing. These bearings are for crankshafts that have been ground smaller than the original size.Main Bearings
Main bearings are available with a larger outside diameter than the original size bearings. These bearings are available for the cylinder blocks with the main bearing bore that is made larger than the bores' original size. The size that is available has a 0.63 mm (0.025 inch) outside diameter that is larger than the original size bearings.Cylinder Block
Illustration 1 g00294303
1P-3537 Dial Bore Gauge Group If the main bearing caps are installed without bearings, the bore in the block for the main bearings can be checked. Tighten the nuts that hold the caps to the torque that is shown in the Specifications. Alignment error in the bores must not be more than 0.08 mm (0.003 inch). Refer to the Special Instruction, SMHS7606.Projection Of Cylinder Liners
Table 1
Tools Needed    
Part Number     Description     Quantity    
8B-7548     Push-Puller     1    
3H-0465     Plate     3    
1P-2396     Puller Plate     1    
3/4 - 16 177.8 mm 7.0 inch long     NF Bolt     2    
3/4 - 16 76.2 mm 3.0 inch long     NF Bolt     4    
2F-0126     Seals     8    
8T-0455     Liner Projection Tool Group     1    
8S-3140     Cylinder Block Counterboring Tool     1    
Illustration 2 g00332134
Holding the top plate to the cylinder block (1) 3H-0465 Push Puller Plate. (2) 1P-2396 Puller plate. (3) 2F-0126 Seal. (4) Top plate.Use the following steps to check the liner projection above the top plate.
Ensure that the top plate (4) and the cylinder liner flange are clean.
Install a new spacer plate gasket.
Install the cylinder liners in the cylinder block without seals or bands.
Use 3/4 - 16 NF bolts that are 76.2 mm (3.0 inch) long. Use two 2F-0126 Seals (3) on each bolt. These seals will hold the top plate (4) to the cylinder block. Install two bolts with seals (3). Install the bolts on each side of the