SOLENOID GP-SHUTOFF 7C7695 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1U-7638     Magnetic Holding Tool     18    
B     201-4211     Camshaft Pilot     1    
201-4212 Camshaft Pilot     1    Start By:
Remove the rocker arms and shafts. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Remove".
Remove the front cover. Refer to Disassembly and Assembly, "Front Cover - Remove".
Remove the camshaft position sensor. Refer to Disassembly and Assembly, "Camshaft Position Sensor - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Turn the crankshaft to top center compression stroke for the No. 1 piston. Install the timing bolt in the flywheel. This is for timing during installation.
Ensure that the timing marks on the following gears are aligned: the camshaft drive gear, the idler gear and the crankshaft gear.
Illustration 1 g01292424
Note: It is not necessary to remove the cylinder head for removal of the camshaft.
Install Tooling (A) in order to support the lifter. Repeat for all the remaining lifters.
Illustration 2 g01011039
Remove bolts (1) .
Illustration 3 g01372193
Remove tube assemblies (4). Remove bolts (2) and remove cover (3) .
Illustration 4 g01325027
Install Tooling (B) onto the camshaft.
Illustration 5 g01292425
Note: Lubricate Tooling (B) for easier removal of the camshaft. Lubrication also prevents damaging the camshaft lobes and the camshaft bearings.
Carefully remove camshaft (6) from the engine. Support the weight of the camshaft during removal.Note: Rotate the camshaft during removal. This will prevent the camshaft from binding in the camshaft bearings.