SPACER 0305807 - Caterpillar

Removal Procedure
Park the machine on a hard, level surface. Engage the parking brake and chock the wheels in order to prevent the machine from moving.
Illustration 1 g00495301
Start the engine and raise the scraper bowl until the scraper bowl is level. Place two 445 kN (50 ton) screw jacks under the scraper bowl. Shut off the engine.
Illustration 2 g00495302
Place a suitable lifting device under the floor link. Remove two bolts (1) and bar (2) from floor (3) . Use a hammer and a brass rod to remove pin (4) from floor (3) . Lower the floor link to the ground.
Illustration 3 g00495303
Place a suitable lifting device under the floor. Release the weight from the sliding floor rollers. Remove four bolts (5) and the shims from floor rollers (6) . Remove floor rollers (6) from floor (3) . Repeat the procedure for the other side.
Illustration 4 g00495329
Carefully lower the floor and slowly lower the floor. Remove the floor from the scraper bowl. The floor weighs 910 kg (2006 lb) .Installation Procedure
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Illustration 5 g00495329
Carefully raise the floor and slowly raise the floor. Install the floor to the scraper bowl. The floor weighs 910 kg (2006 lb) .
Illustration 6 g00495303
Install floor rollers (6) to floor (3) . Install four bolts (5) and the shims to floor rollers (6) . Adjust the floor rollers. Refer to Specifications, SENR8666 for information on adjusting the floor rollers. Remove the suitable lifting device from the floor. Repeat the procedure for the other side.
Illustration 7 g00495302
Position the floor link to the floor. Use a soft faced hammer to install pin (4) to floor (3) . Install bar (2) and two bolts (1) to floor (3) . Remove the tooling from the floor link.
Remove the tooling from the scraper bowl.