SPACER 0857329 - Caterpillar

Specification
Table 1
"Machine Drift on a Slope - Check"
Drift mm (inch)
New Service Limit Actual
0 0 Introduction
Measuring the amount of drift of the machine on a slope will determine if there is a need to check the travel brake.Note: The engine speed and/or the machine configuration that is used during this test can affect the results of this test. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for the engine speed that was used for this test. Refer to Testing and Adjusting, "Operational Checks" for the machine configurations that were used for this test.Note: The relief valve pressure settings must be set to the relief valve pressure specification before performing this operational check. Refer to Testing and Adjusting, "Specifications".Required Tools
Table 2
Required Tools
Description Qty
Stopwatch 1
Scale 150 mm (6 inch) 1 Test Procedure
Illustration 1 g03506702
Place the machine on a slope of 12 degrees. The surface of the slope must be hard and smooth.
Position the implements, as shown. Refer to Illustration 1.
The bucket should be empty.
Illustration 2 g01186214
(A) Mark on roller frame
(B) Mark on track
To indicate the relative position of the machine to the slope, put a mark on both the track and the track roller frame. Refer to Illustration 2.
Stop the engine.
Measure the machine movement on the slope after 3 minutes. Refer to Table 1 for specification.