SPACER 1005072 - Caterpillar

For all generator maintenance activities, refer to SEBU6918, the Generator and Control Panel Operation and Maintenance Manual.Use fuel consumption, service hours, or calendar time, whichever occurs first, to determine maintenance intervals. Experience has shown that maintenance intervals are most accurately scheduled on the basis of fuel consumed rather than service hours.Daily
Walk-Around Inspection -Inspect engine for leaks and loose connections Engine Crankcase -Check oil level Cooling System -Check coolant level Air Cleaner -Check service indicator/Service air cleaner when needed Air Starter Lubricator (If Equipped) -Check fluid level/Adjust oiler feed Air Tank (If Equipped) -Drain water/Check pressureEvery 1,900 L (500 gal) of Fuel or 50 Hours
Air Cleaner -Clean Precleaner (If Equipped)/Replace Light Duty Air Cleaner (If Equipped)First 8,500 L (2,200 gal) of Fuel or 250 Hours (First Oil Change)
Engine Valve Lash -Check/Adjust Magnetic Pickup -Inspect/AdjustEvery 8,500 L (2,200 gal) of Fuel or 250 Hours
Scheduled Oil Sampling (S O S) -Obtain Sample and analysis Engine Crankcase -Replace oil and filter(s) Crankcase Breather -Clean Cooling System (Conventional Coolant/Antifreeze Only)-Test for SCA concentration OR obtain Level I coolant analysis/Add SCA if necessary Fuel System -Clean primary fuel filter (if equipped)/Replace final fuel filter Fuel Tank -Drain water and sediment Radiator, Aftercooler (If Equipped) -Clean/Inspect Belts -Check/Adjust Hoses -Inspect/Replace Fan Drive Bearing -Lubricate Batteries -Clean/Check (if required)Every 34,000 L (9,000 gal) of Fuel or 1000 Hours
Engine Protection Devices -Inspect/Check Fuel Control Linkage-Check/LubricateEvery 67,000 L (18,000 gal) of Fuel or 2000 Hours
Engine Valve Lash, Valve Rotators -Check/Adjust Fuel Ratio Control, Set Point, and Low Idle -Check/Adjust Fuel Injection Nozzles -Test/Exchange Turbocharger -Clean/Inspect/Check Engine Mounts -Inspect Crankshaft Vibration Damper -InspectEvery 91,000 L (24,000 gal) of Fuel or 3000 Hours or Two Years
Temperature Regulator (Thermostat) - Replace Cooling System (Long Life Coolant/Antifreeze Only)-Add Extender Cooling System (Conventional Coolant/Antifreeze Only)-Drain/Clean/Replace Coolant Water Pump -Inspect/Replace sealEvery 136,000 L (36,000 gal) of Fuel or 4000 Hours
Magnetic Pickup -Inspect/AdjustEvery 204,000 L (54,000 gal) of Fuel or 6000 Hours or Four Years
Cooling System (Long Life Coolant/Antifreeze Only)-Drain/Flush/Replace Coolant