SPACER 1472477 - Caterpillar

Illustration 5 g01268022
Press the "OK" key to confirm selection.Refer to Illustration 6.
Illustration 6 g01268023
Method: "1 Point Focus"
The "1 Point Focus" method sets one vertical guidance point 0.2 m (0.6 ft) in from the bucket tip that has focus. Use this method when you are working on a narrow section of the design where the cross slope does not change (for example, the shoulder of a road). Guidance changes with respect to the bucket tip focus.
Use the arrow keys to highlight the "3D, 1 Point Focus" method.Refer to Illustration 7.
Illustration 7 g01268024
Press the "OK" key to confirm selection.Refer to Illustration 8.
Illustration 8 g01268025
Method: "2 Points Tips"
The "2 Points Tips" method sets two vertical guidance points 0.2 m (0.6 ft) in from each bucket tip. Use this method when you are working on an irregular design surface, where the cross slope changes across the width of the bucket (for example, a golf course). Guidance does not change with respect to the bucket tip focus.
Use the arrow keys to highlight the "3D, 2 Point Tips" method.Refer to Illustration 9.
Illustration 9 g01268026
Press the "OK" key to confirm selection.Refer to Illustration 10.
Illustration 10 g01268027
Method: "1 Point Custom"
The "1 Point Custom" method lets you set one vertical guidance point at a customized distance from the bucket tip with focus.In order to configure the "1 Point Custom" method, complete the following steps:
Use the arrow keys to highlight the "3D, 1 Point Custom" method.Refer to Illustration 11.
Illustration 11 g01268028
Press the "OK" key to confirm selection.
Press the "NEXT" key in order to highlight a field.Refer to Illustration 12.
Illustration 12 g01280825
Press the arrow keys in order to enter a value into the field."A" is the horizontal distance from the bucket tip with focus to the guidance point. The vertical guidance point will change sides of the bucket when the focus point changes. A must