SPACER 1620303 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     FT-1114     Vacuum Cap     1    Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release" for the machine that is being serviced.
Remove the cab floorplate. Refer to Disassembly and Assembly, "Floorplate - Remove and Install" for the machine that is being serviced.Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Perform one of the following two Steps.
Use Tooling (A) and shop air to place a vacuum on the hydraulic tank.
Drain the hydraulic oil tank into a suitable container for storage or disposal. The capacity of the hydraulic tank is 49.2 L (13 US gal).
Illustration 1 g00614512
Loosen two hose clamps (1) and disconnect hose (2) .
Disconnect hose assembly (3) .
Remove four bolts (4) and the flange (hidden).
Disconnect hose assembly (6) .
Disconnect hose assembly (5) .
Illustration 2 g00614515
Illustration 3 g00614518
Attach a hoist and suitable lifting slings to pump (7) .
Remove four mounting bolts (8) and pump (7). The weight of pump (7) is approximately 45 kg (100 lb).