SPACER 1F6328 - Caterpillar

2. Install the 8S-9971 Ram Adapter (1) of Tooling (A) on the ram, and install the 9S-0032 Plug (2) of Tooling (A) in the ram adapter. Install the changed 1P-3483 Pin Adapter (6) of Tooling (A) on the frame with the counterbore toward the ram. Put the 2S-8235 Bushing Adapter (3) of Tooling (A) in bushing (4).3. Put clean SAE 90 oil on the outside diameter of the bushing that makes contact with the links. Use Tooling (A) as shown to push bushing (4) into the bore in link (5) until the bushing makes contact with the counterbore in pin adapter (6). The bushing must extend past the outer surface of the link 1.88 0.25 mm (.074 .010 in). 4. Clean both ends of bushing (7) until they are clean and dry. Put clean SAE 90 oil on both ends of the bushing. 5. Make sure the seals, load rings and thrust rings are clean and dry. If the seals were removed from the links, install load rings (8) and seals (9) in the links as shown. Put clean SAE 90 oil on the lip of the seals only.
Do not put oil on load rings (8). Oil will cause the load rings to become larger (swell).
6. Put the 5F-9451 Pilot Pin (11) of Tooling (A) in the bushing with the tapered end of the pin as shown. Install thrust rings (12) on the pilot pin. Install link (10) on the pilot pin. 7. Put the assembled bushing (4) and link (5) in position on link (10) and pilot pin (11), and use Tooling (A) as shown to push the bushing into link (10) until the bushing makes contact with the counterbore in pin adapter (6). Remove Tooling (A).8. If the track is to be assembled without lubricant or if lubrication Tooling is available, go to Step 13. If the track is to be assembled with lubricant and lubrication tooling is not available, use a .5 in. drill to remove the rubber stopper and plastic plug from the track pins. Be sure the oil reservoir hole and crosshole are clear. 9. Put clean SAE 90 oil on rubber stopper (13), and put the rubber stopper in sleeve (14) of Tooling (B) as shown. 10. Put tape (16) over the crosshole in track pin (15). Fill the track pin with clean SAE 90 oil. Use Tooling (B) as shown to install rubber stopper (13) to the correct depth in track pin (15). 11. Install plastic plug (17) in the rubber stopper with the point in.12. Do Steps 8, 9, 10 and 11 for the other track pin. 13. Remove pin adapter (6) from the frame of Tooling (A). Turn the pin adapter around, and install it in the frame with the flat side toward the ram.14. Put track pin (15) in ram adapter (1) of Tooling (A) with oil hole (18) up toward the link rails as shown and with the rubber stopper on the same side as