SPACER 1H0727 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     8S-2244     Pump Extractor     1    
B     6V-4186     Fuel Pump Timing Pin     1    
C     8T-5287     Wrench     1    
D     6V-9128     Rack Position Tool Group    
1    
3S-3270 Indicator Contact Point     1    
C-clamp 1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00507964
Install spacer (1) in the fuel injection pump housing.
Illustration 2 g00507989
Illustration 3 g00508002
Install Tool (B) in the fuel injection pump housing. Move the rack until Tool (B) can be installed in order to hold the rack in the center position. The rack must be in the center position in order to install the fuel injection pumps.
Turn the camshaft until the lobe of the camshaft is downward so that the fuel injection pump can be installed.
Install Tool (A) on the bonnet of the fuel injection pump.
Install the fuel injection pump in the fuel injection pump housing. Ensure that slot (3) that is cut in the gear is aligned with the small pin (2) and groove (4) in the barrel. The small pin (2) and groove (4) in the barrel are aligned with dowel (5) in the fuel injection pump housing.
Illustration 4 g00508005
Put clean engine oil on O-ring seal (6) and install the O-ring seal in the fuel injection pump housing.
Illustration 5 g00508057
Install bushing (7) by hand until the bushing is even with the top of the fuel injection pump housing. If bushing (7) cannot be installed by hand, remove bushing (7). Remove the fuel injection pump. Put the pump in alignment and reinstall bushing (7) .
Install Tool (C) on bushing (7) and tighten the bushing to a torque of 163 14 N m (120 10 lb ft).
Install Tool (D) in order to measure the total travel of the rack. The correct travel for the rack is 15.70 mm (.618 inch). A smaller measurement is an indication of improper fuel injection pump installation.
Repeat Steps 1 through 9 in order to install the remaining fuel injection pumps.
Install the cover and the gasket on the fuel injection pump housing.