SPACER 2046365 - Caterpillar

Illustration 1 g02573246
(1) Clutch 1 (2) Clutch 2 (3) Clutch 3 (4) Clutch 4 (5) Clutch 5 (6) Input shaftThe planetary transmission has six forward gears and one reverse gear. REVERSE and NEUTRAL use only torque converter drive. At lower ground speeds, FIRST gear and SECOND gear use torque converter drive. As the ground speed increases in FIRST gear or in SECOND gear, the lockup clutch of the torque converter engages. This function provides FIRST gear or SECOND gear with direct drive. The torque converter is always in direct drive for gears THIRD through SIXTH. However, there is a short period of torque converter drive when the clutches engage in the planetary transmission. This function provides smooth, automatic upshifting from THIRD through SIXTH and smooth, automatic downshifting from SIXTH through THIRD. Table 1 shows the clutches that are engaged for each gear.
Table 1
GEAR SELECTION    
GEAR    ENGAGED CLUTCHES    
REVERSE     3 and 5    
NEUTRAL     5    
FIRST     1 and 5    
SECOND     1 and 4    
THIRD     1 and 3    
FOURTH     1 and 2    
FIFTH     2 and 3    
SIXTH     2 and 4    The planetary transmission consists of two rotating clutches, three stationary clutches, and three planetary units. This configuration provides six forward gears and one reverse gear. No. 1 clutch (1) and No. 2 clutch (2) are the rotating clutches.The planetary transmission is bolted to the housing for the torque converter. Input shaft (6) for the planetary transmission is splined and bolted to the torque converter.The input shaft (6) is also splined to the retarder for transmissions that are equipped with a retarder.
Illustration 2 g02574157
(7) Engine speed sensor (8) Transmission output speed sensor (9) Electronic control module (10) Torque converter output speed sensorEngine speed sensor (7), torque converter output speed sensor and the transmission output speed sensors (8) are used to monitor the various speeds of the transmission. The information from these speed sensors is sent to the transmission ECM (Electronic Control Module). The ECM uses the information to control the shifting and calibration of the transmission.