SPACER 2B0941 - Caterpillar

Note: This is not a fault in the electronic system.Probable Causes
Engine oil cooler
Cylinder head gasket
Cylinder head
Cylinder blockRecommended Actions
Engine Oil Cooler
Drain the engine lubricating oil from the engine.
Check for leaks in the oil cooler assembly. Refer to Systems Operation, Testing and Adjusting, "Cooling System" for the correct procedure. If a leak is found, install a new oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler - Remove" and Disassembly and Assembly, "Engine Oil Cooler - Install" for the correct procedure. Cylinder Head Gasket
Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove" for the correct procedure.
Inspect the cylinder head gasket for faults and any signs of leakage.
To fit a new cylinder head gasket, refer to Disassembly and Assembly, "Cylinder Head - Install" for the correct procedure.
If there was no obvious signs of a faulty head gasket proceed to the recommended actions for "Cylinder Head". Cylinder Head
Check the cylinder head for flatness. Refer to Systems Operation, Testing and Adjusting, "Cylinder Head - Inspect" for the correct procedure.
Check the mating face of the cylinder head for faults and signs of leakage. If a fault is found, replace the cylinder head. If signs of leakage are found, determine the cause of the leakage. Refer to Systems Operation, Testing and Adjusting, "Cylinder Head - Inspect" for the correct procedure.
Check the internal core plugs in the cylinder head for signs of leakage.
If the cylinder head is flat and if the cylinder head does not have any faults, refer to "Cylinder Block". Cylinder Block
Inspect the top face of the cylinder block for faults and signs of leakage. If a fault is found, replace the cylinder block. If signs of leakage are found, determine the cause of the leakage. Refer to Systems Operation, Testing and Adjusting, "Cylinder Block - Inspect" for the correct procedure.Assembly after Repair
Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".
Remove the oil filter element. Install a new engine oil filter element. Fill the engine with clean engine oil to the correct level. Refer to the Operation and Maintenance Manual, "Engine Oil and Filter - Change" for more information.