SPACER 2L0769 - Caterpillar

Installation
Table 1
Required Parts
Item Part Number Part Name
1 339-6185 Tape(1)
2 7K-1181 Cable Strap(2)
3 420-9999 Sleeve(3)
(1) The tape roll is 25 m (27 yd) long and is enough to install approximately 200 sleeves.
(2) Two cable straps are required for each sleeve.
(3) The sleeve is 89 mm (3.5 in) long.
Illustration 1 g03896598
(1) 339-6185 Tape
Illustration 2 g03896600
(1) 339-6185 Tape
(2) 7K-1181 Cable Strap
(3) 420-9999 Sleeve
Locate sleeve (3) onto the drive hose in locations where the hose might be susceptible to rubbing machine components.Note: If an existing hose has a fabric sleeve covering, cut and remove the fabric from the area where a sleeve is to be installed.
Wrap approximately 125 mm (5 in) or one and half wraps of tape (1) under each end of the sleeve. The tape provides friction under the sleeve to prevent the sleeve from sliding out of the desired location.
Secure the sleeve in place by installing a cable strap (2) at each end of the sleeve.