SPACER 3271105 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not open the high pressure fuel system without allowing the fuel system to purge. After the engine has shut down, allow the fuel system to purge for ten minutes. This operating fuel system contains high pressure. Exposure to high pressure fuel can result in personal injury.
Note: Use Tooling (B) to cap tube assemblies, fittings, ports, and any opening in the fuel system in order to prevent contamination.Note: Do not remove all the quills in order to maintain the alignment of the rail. Remove one at a time and replace before the removal of the next. If necessary, replace with new quill.
Illustration 1 g02087086
Remove bolt (3) and the washer. Remove tube assembly (1) . Disconnect harness assembly (2) .
Illustration 2 g03372986
Apply clean engine oil to area (X) . Repeat for the opposite collar. Remove and discard bolts (4) and (6) . Remove tube assembly (5) .
Illustration 3 g02087090
Use Tooling (A) to remove flow limiter (7) from the fuel rail.Note: Apply protective caps to flow limiter (7 ) in order to prevent contamination. Clean Tooling (A) before using in order to avoid contamination in the fuel system.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     6V-6195     Interlocking Joint Pliers     1    
B     339-9352     Inj. Sys Cap Kit     1    
265-2256 Wipers     1    Note: When Tooling (B) is removed be careful to prevent contamination.
Illustration 4 g02087090
Apply clean engine oil to the sealing face of the flow limiter and the fuel rail.Note: Use a clean plastic squirt bottle to apply clean engine oil. Do not apply clean engine oil by hand.
Use Tooling (A) to install flow limiter (7) into the fuel rail.Note: Clean Tooling (A) before using in order to avoid contamination in the fuel system.
Illustration 5 g03373841
Illustration 6 g03373378
Illustration 7 g03373506
Remove bolt (9) from injector unit (8) .
Replace external O-ring seals on quill tube assembly (5) . Apply clean engine oil to Area (X) . Install quill tube assembly (5) .Note: Do not allow the quill tube assembly (5) to contact any part of the engine while assembling.
Install new bolts (4) and (6) hand-tight.
Install bolt (9) and tighten to a torque of 10 N m (89 lb in).
Evenly tighten bolts (4) to a torque of 20 N m (177 lb in) in increments no greater than 90 degrees. Evenly tighten bolts (6) to a torque of 20 N m (177 lb in) in increments no greater than 90 degrees.
Tighten injector bolt (9) to a torque of 100 20 N m (74 15 lb ft).
Evenly tighten bolts (4) to a torque of 40 5 N m (30 4 lb ft)in increments no greater than 45 degrees. Evenly tighten bolts (6) to a torque of 40 5 N m (30 4 lb ft) in increments no greater than 45 degrees.
Illustration 8 g02087086
Connect harness assembly (2) . Replace the O-ring seals on both ends