SPACER 3456627 - Caterpillar

Illustration 2 g01807533
The hydraulic lift and tilt capacity of the machine is calculated throughout the entire Hinge (B) Pin Height range with the forks level. The capacity curves contain information for both the lift and the tilt capacity as seen in Illustration 2.Note: Depending on the machine configuration, pallet fork, and load center selected, the hydraulic lift capacity could be large enough that it is greater than the maximum value in the plot area as seen in Illustration 2. Consequently, the lift capacity does not show up in the plot area.992G
Fork Specifications
Illustration 3 g01809335
Table 1
Specifications for 992G using a 343-5533 Pallet Fork    
(1)     Tine Length    
3048 mm (120 inch)    
(2)     Load Center    
1524 mm (60 inch)    
    Static Tipping Load - Straight (Forks Level)    
39160 kg (86333 lb)    
    Static Tipping Load - Articulated (Forks Level)    
32943 kg (72627 lb)    
    Rated Load (SAE J1197 - 50% FTSTL)    
16472 kg (36315 lb)    
    Rated Load (CEN EN 474-3 Rough Terrain - 60% FTSTL)    
19766 kg (43577 lb)    
    Rated Load (CEN EN 474-3 Firm and Level Ground - 80% FTSTL)    
26354 kg (58101 lb)    
(3)     Maximum Overall Length    
17282 mm (680.39 inch)    
(4)     Reach with Forks at Ground Level    
5829 mm (229.48 inch)    
(5)     Ground to Top of Tine at Minimum Height and Fork Level    
150 mm (5.90 inch)    
(6)     Reach with Arms Horizontal and Forks Level    
3623 mm (142.64 inch)    
(7)     Reach with Fork at maximum Height    
1475 mm (58.07 inch)    
(8)     Ground to Top of Tine with Arms Horizontal and Fork Level    
3086 mm (121.49 inch)    
(9)     Ground to Top of Tine at Maximum Height and Fork Level    
7368 mm (290.08 inch)    
(10)     Overall Height of Fork at Full Lift (top of carriage to ground)    
10416 mm (410 inch)    
(11)     Clearance at Full Lift and Max Dump    
4408 mm (173.54 inch)    
(12)     Max Discharge Angle from Horizontal     50 degrees    
(13)     Carriage Width    
3913 mm (154.05 inch)    
(14)     Carriage Height    
2850.4 mm (112.22 inch)    
(15)     Outside Tine Width (max spread)    
3673.4 mm (144.62 inch)    
(16)     Outside Tine Width (min spread)    
3368.6 mm (132.62 inch)    
    Tine Width (single tine)    
300 mm (11.81 inch)    
    Tine Thickness    
150 mm (5.90 inch)    
    Operating Weight    
98455 kg (217056 lb)    Load Curve Chart
Illustration 4 g01859867
992G with 343-5533 Pallet Fork Rated Load for the Tine
To prevent injury, do not exceed the rated load capacity that is stamped in the side of each fork tine.
Illustration 5 g01860413
(1) Location of stamped load rating for the tine
Illustration 6 g01860414
(2) Part number of the tine (3) Dimensions for length, width, and thickness of the tine (4) Load rating for the tine at the load