SPACER-SPECIAL 3512196 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-5809 Electric Hydraulic Pump Gp 1
9U-7536 Lift Stand 2
B 132-8223 Hydraulic Pump and Motor Gp 1
132-8119 Hydraulic Torque Wrench 1
C 176-6536 Forcing Bolt 2 Start By:
Separate the track assembly. Refer to Disassembly and Assembly, "Track - Separate". Note: The procedure to remove the right hand final drive sprocket and the procedure to remove the left hand final drive sprocket is identical. The procedure that follows is for one of the final drive sprockets.
Illustration 1 g00874894Note: Adjust the height of Tooling (A) so that there is sufficient clearance between the sprocket and the track links for the removal of the sprocket from the final drive.
Lift the side of the machine in order to install Tooling (A) under the frame.
Illustration 2 g00874908
Use Tooling (B) to remove bolts (1).
Illustration 3 g00874919
Remove two cork plugs (2). Use Tooling (C) to separate the sprocket from the final drive.
Illustration 4 g00874960
Use a hoist and a lifting sling to remove sprocket (3). The weight of sprocket (3) is approximately 140 kg (310 lb). Installation Procedure
Note: The procedure to install the right hand final drive sprocket and the procedure to install the left hand final drive sprocket is identical. The procedure that follows is for one of the final drive sprockets.
Thoroughly clean the mating surfaces of the sprocket and the final drive.
Illustration 5 g00874960
Use a hoist and a lifting sling to position sprocket (3). The weight of sprocket (3) is approximately 140 kg (310 lb).
Illustration 6 g00874908
Use 9S-3263 Thread Lock Compound on bolts (1). Install bolts (1). Use Tooling (B) to tighten bolts (1) in a crisscross sequence to a torque of 2000 250 N m (1475 185 lb ft).
Illustration 7 g00874919
Install two cork plugs (2).
Illustration 8 g00874894
Remove Tooling (A). End By:
Connect the track assembly. Refer to Disassembly and Assembly, "Track - Connect" in this manual.