SPACER-FAN 3692258 - Caterpillar

72. Assemble hub (63) to gear (61). If removed install sleeve bearing (64).73. Use Tool (G) to install retaining ring (62). 74. Install gear and hub assembly (61). 75. Use Tool (D) to install retaining ring (59) and install thrust disc (60). 76. Attach eye bolt to shaft assembly (58) as shown. There are three plugs on the end of the shaft assembly. Use Tool (B) to remove if necessary. Seal lip must face toward the tip of balance piston (53) as shown.77. Check lip seal (57) on balance piston (53) for damage or wear and replace if necessary. Seal lip must face toward the top of piston (55) as shown.78. Check lip seals (56) on piston (55) for damage or wear and replace if necessary. 79. Install piston (55). 80. Install wave spring (54). 81. Install balance piston (53). 82. Position the shaft assembly so snap ring (52) lines up with the opening on Tool (H). 83. Install Tool (H), (J), and (I) to compress the wave spring (not shown). Use Tool (D) to install snap ring (52) and remove Tool (H). Install Tool (L) for aligning friction and discs. 84. Use Tool (D) to install snap ring (51). 85. Install one end plate (48), clutch plates (49) and friction discs (50). 86. Use a screw driver to install retaining ring (47). 87. Use Tool (E) and a suitable air nozzle to measure the travel of the clutch pack. This step was performed in the disassembly to obtain the desired travel for the assembly. 88. Install thrust disc (45) and ring retainer (46). 89. If removed install sleeve bearing (44). When installing sleeve bearing (44), press to a depth of 10 mm (.4 in) from hub face.90. Assemble hub assembly (43) from gear (41).91. Use Tool (G) to install retaining ring (42). 92. Install gear and hub assembly (41). 93. Install thrust disc (40). 94. Install gear (39). 95. Use Tool (D) to install retaining ring (38). 96. Install thrust disc (37).
When installing thrust disc (37), apply 1P-0808 General Purpose Lubricant to the backside of thrust disc (37), this will help hold thrust disc (37) in position for assembly.
97. Install four seal rings (36). 98. Use an eye bolt and a suitable lifting device to reposition the shaft assembly. 99. Install balance seal assembly (33), wave spring (34) and piston seal assembly (35).
Typical Example100. Install piston seal assembly (35). 101. Install wave spring (34). 102. Install balance seal assembly (33). 103. Position the shaft assembly so retaining ring (32) lines up with the opening on Tool (F). Install Tool (F), (J), and (I) to compress the wave spring (not shown). Use Tool (D) to install retaining ring (32). Release the pressure on the wave spring and remove Tool (F). Install Tool (K) for aligning friction and discs. 104. Install one end plate (29), clutch plates (31) and disc assembly (30). 105. Use a screwdriver to install retaining ring (28). 106. Use Tool (E) and a suitable air