SPACER 4200940 - Caterpillar

Setup Menu - Configuration
Items in the Setup Menu – Configuration dialog include troubleshooting items as well as system variables and settings. By default, some of these items are visible in Service Mode only, while others are visible in all modes. The options are as shown in Table 1.
Table 1
This Setup Menu - Configuration Item ...     Is Available In These Modes (by default) ...    For more information, refer to ...    
Blade Wear     All modes     Systems Operation, "Blade Wear"    
Vertical Guidance (1)     All modes     Systems Operation, "Vertical Guidance Method"    
Vertical Offset Switch Increment     Service mode     Systems Operation, "Vertical Offset Increment"    
GPS Accuracy Mode (1)     All modes     Systems Operation, "GPS Accuracy Mode"    
Lightbar Scales     All modes     Systems Operation, "Light Bar Scales"
   
Display and Lightbar Brightness Setting     Service mode     Systems Operation, "Display and Light Bar Brightness (Display and Lightbar)"    
Map Recording     Service mode     Systems Operation, "Map Recording"    
Valve Speed     Normal and Service mode     Testing and Adjusting, "Blade Reaction Time - Adjust"    
Calibrate Sensors (2)     Service Mode     Testing and Adjusting, "Angle Sensor - Calibrate"    
Avoidance Zone     Service mode     Systems Operation, "Avoidance Zone"    
Text Items     Service mode     Systems Operation, "Text Items"    
Plan View Rotation     Service mode     Systems Operation, "Plan View Rotation"    
Beeper     Service mode     Systems Operation, "Beeper"    
Save Settings     Service mode     Systems Operation, "Display Settings"    
Restore Settings     All Modes     Systems Operation, "Display Settings"    
GPS Receiver Configuration     All Modes     Systems Operation, "Receiver Configuration"    
Diagnostics     Normal and Service mode     Troubleshooting, " Diagnostic Capabilities"    
( 1 ) Version 5.5 only
( 2 ) Version 6.1 onlySetup Menu - Installation
Items listed under the Setup Menu - Installation dialog include items used when you install or reinstall an AccuGrade System, or to update the device firmware. In order to access the Setup Menu - Installation dialog, press the Soft Key (Installation). By default the Setup Menu - Installation dialog is only available in Service mode. However the operator configuration can be customized so that some or all of the Setup Menu - Installation dialog is available in Normal mode.Depending on the current machine configuration, different options are available from the Setup Menu - Installation dialog. The options are shown in table 2.
Table 2
This Setup Menu item ...     in these modes (by default) ...    For more information, refer to ...    
Machine Settings     Service Mode     Testing and Adjusting, "Machine Type"    
Units     Service Mode
    Systems Operation, "Display Units"    
Machine Dimensions     Service Mode     Testing and Adjusting, "Machine Dimensions - Set"    
Lightbar Connections     Service Mode     Testing and Adjusting, "Light Bar - Set"    
Slope Calibration (1)     Service Mode     Testing and Adjusting, "Angle Sensor - Calibrate"    
Valve Calibration     Service Mode     Testing and Adjusting,