SPACER 4869829 - Caterpillar

Illustration 1 g00778381
(A) Boom cylinder (B) Stick cylinder (C) StickNote: All bores must be free of paint. Coat all bores for pins with lubricant.Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (1) Two 192-8261 Sleeve Bearings Outside diameter ... 140.198 .011 mm (5.5196 0.0004 inch) Inside diameter ... 120.320 .020 mm (4.7370 0.0008 inch) Installation depth for the sleeve bearing in the bearing bore ... 9.5 0.8 mm (0.37 0.03 inch) (2) Lubricate the sealing lip slightly with the lubricant that is being sealed. (3) 192-8321 Pin Diameter after plating ... 109.850 .040 mm (4.3248 0.0016 inch) Plating thickness for the first layer ... 0.015 mm (0.0006 inch) Plating thickness for the second layer ... 0.015 mm (0.0006 inch) Bore diameter for pin ... 110.043 .043 mm (4.3324 0.0017 inch) (4) 113-2963 Pin Assembly Diameter after plating ... 89.850 .025 mm (3.5374 0.0010 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for pin ... 90.043 0.043 mm (3.5450 0.0017 inch) (5) 192-8352 Pin Assembly Diameter after plating ... 99.850 0.025 mm (3.9311 0.0010 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for pin ... 120.043 0.043 mm (4.7261 0.0017 inch) (6) Use the necessary shims to adjust the lateral clearance. Maximum clearance ... 1.6 mm (0.063 inch) 147-3957 Shim ... 0.5 mm (0.02 inch) 093-0074 Shim ... 1.0 mm (0.04 inch) 166-1490 Shim ... 2.0 mm (0.08 inch)