SPACER 4F7566 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
1 3E6788 SEAL-O RING
2 5P8068 SEAL-O-RING
1 6V3834 SEAL-O-RING
3 6V5134 SEAL-O-RING
1 8J4351 SEAL-O-RING
1 20R6161 PUMP GP-ENG OIL
1 3464897 SEAL-O-RING
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 45% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Replace existing engine oil pump with the engine oil pump that is listed in the Parts Needed. Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 6.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
Rework Procedure
IF the Engine Oil Pump is NOT PAINTED the pump has already been replaced with a known good pump and does not need to be replaced.
1. Refer to Disassembly and Assembly, UENR0184, "Engine Oil Pump - Remove and Install".
2. When reinstalling the 456-001 Oil Jumper tube use the Assembly Aid (Image 1.1.1) to protect the o-ring from being cut on the tube.
3. When refilling the engine coolant be sure to get all the air out of the system to protect the NRS Cooler. Preferred coolant refill method is to vacuum fill. If that is not an option run engine at idle without pressure cap installed not allowing the system to pressurize. Make sure to reinstall pressure cap after air has purged out. Do not run the engine this way for over five minutes.
Image1.1.1