SPACER 6S9571 - Caterpillar

Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 439-3938 Link Bracket 1 Start By:
Remove axle shaft.
Illustration 1 g00519500
Install Tooling (A) to final drive (1). Attach a suitable lifting device to Tooling (A). The weight of final drive (1) is approximately 130 kg (287 lb).Note: The weight of final drive (1) may vary according to the models.
Illustration 2 g00519502
Remove three bolts (2) from final drive (1).
Illustration 3 g06137448
Remove final drive (1) from wheel assembly (3).
Remove O-ring seal (4) from final drive (1).
Illustration 4 g01122231
Use Tooling (A) and a suitable lifting device to support final drive (1). Position final drive (1) on a suitable block, as shown.
Slowly remove planetary shaft (5) from planetary carrier (1). Planetary shaft (5) is a slip fit.
Illustration 5 g01086173
Remove thrust washer (10), gear (9), and thrust washer (6) from the planetary carrier.
Remove sleeve bearing (7) from gear (9).
Remove pin (8) from planetary shaft (5).
Repeat steps 6 through 9 for the removal of the other two planetary gears.