SPACER 7E3667 - Caterpillar

Ensure that all safety information, warnings and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of all maintenance which includes the following items: performing all adjustments, using proper lubricants, fluids, and filters and replacing old components with new components due to normal wear and aging .Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. All of the following will affect the oil change interval: operating conditions, fuel type and oil type . Scheduled oil sampling analyzes used oil in order to determine if the oil change interval is suitable for your specific engine. Refer to this Operation and Maintenance Manual, "Engine Oil and Filter - Change" in order to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual, "Maintenance Recommendations" .When Required
Engine Air Cleaner Element (Single Element) - Clean/Replace
Fuel System - Prime
Maintenance Recommendations
Zinc Rods - Inspect/Replace
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Cooling System Coolant Level - Check
Driven Equipment - Inspect/Replace/Lubricate
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Filter Differential Pressure - Check
Engine Oil Level - Check
Fuel System Fuel Filter Differential Pressure - Check
Fuel Tank Water and Sediment - Drain
Walk-Around Inspection
Every 50 Service Hours
Zinc Rods - Inspect/Replace
Initial 250 Service Hours
Engine Valve Lash - Inspect/Adjust
Fuel Injector - Inspect/Adjust
Speed Sensor - Clean/Inspect
Every 250 Service Hours
Belts - Inspect/Adjust/Replace
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Hoses and Clamps - Inspect/Replace
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Air Shutoff - Test
Every 1000 Service Hours
Engine - Clean
Engine Crankcase Breather - Clean
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fuel System Secondary Filter - Replace
Every 2000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine Mounts - Check
Turbocharger - Inspect
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Every 4000 Service Hours
Engine Valve Lash - Inspect/Adjust
Fuel Injector - Inspect/Adjust
Every 6000 Service Hours
Air Shutoff Damper - Remove/Check
Every 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Cooling System Water Temperature Regulator - Replace
Speed Sensor - Clean/Inspect
Starting Motor