SPANNER-HOOK 1U5833 - Caterpillar

Do not allow the turbocharger to rotate while the engine is not operating. Damage to the turbocharger can result.
In freezing weather, protect the cooling system with antifreeze, to the lowest outside expected temperature on the travel route. Or, drain the cooling system completely.
Comply with any laws that govern the characteristics of a load (length, width, height, and weight).
Move the hydraulic lockout control to the LOCKED position.
Turn the engine start switch to the OFF position in order to stop the engine. Remove the engine start switch key.
Turn the battery disconnect switch to OFF and remove the disconnect switch key.
Remove the ether starting aid cylinder. See Operation and Maintenance Manual, "Ether Starting Aid Cylinder - Replace" for the removal procedure.
Lock the door and the access covers. Attach any vandalism protection.
Hand rails (if equipped) may be repositioned in order to meet the regulations regarding height of some locations. The handrails are located on the rear of the cab and inside the front access door on the left side of the machine. Perform the following procedure in order to lower the hand rails to the transport position.
Illustration 1 g03728817
Loosen the bolts on each handrail bracket.
Lower the handrails to a lower position below the cab roof line.
Tighten the bolts for each handrail bracket. Note: The hand rails must be placed back into the normal operating position before the machine can be placed back into service.
Cover the exhaust opening. Note: Before you remove the machine from the transport machine, remove the protective covering from the exhaust opening.
Chock the wheels and secure the machine with tie-downs. Make sure that you use the proper rated wire cable. Use the front towing eyes on the lower frame, the rear towing eyes on the lower frame, and the rear towing eye that is on the upper frame.Securely fasten all loose parts and all removed parts to the trailer or to the rail car.When the engine is stopped, the swing parking brake is automatically applied. This prevents the upper structure from swinging.Securely fasten all parts that are loose or removed to the trailer or to the rail car. If the machine is equipped with a clamshell, tie the hydraulic hoses to the fork in order to prevent damage to the hydraulic hoses.