SPARK PLUG 2741163 - Caterpillar

Tilt Bucket Sensor Location
Illustration 8 g02209514This dialog is used to tell the Cat Grade Control system the location of the tilt bucket angle sensor. The sensor may be mounted on a tilting quick coupler or on the bucket. A tilting quick coupler allows any bucket to be used as a tilt bucket.The options in this dialog are "On Bucket" or "On Quick Coupler".When the system is configured as "On Bucket", then each tilt bucket that is defined has a unique tilt bucket calibration value that is defined in the "Worktool Select Edit" dialogs. When the system is configured as "On Quick Coupler", then only one tilt bucket calibration value is determined and retained as a result of the tilt bucket sensor calibration procedure.On-Grade Tolerance
Illustration 9 g02211039The "On-Grade Tolerance" dialog is used to configure the on-grade tolerance used to convey "On-grade" status in the depth to grade data and light bar areas.The on-grade tolerance value defines when the system is On-Grade or within a small distance of being close enough to on-grade to be acceptable.For example, if you need to excavate a surface to be within 2 cm (0.79 inch), you would set the on-grade tolerance to be "2cm". Zone 2 will then display a Green Arrow when the bucket is within 2 cm (0.79 inch) of design. The light bar will display On-Grade when the bucket is within 2 cm (0.79 inch) from design.
From the Cat Grade Control menu, select the On-Grade Tolerance icon (4) and press the "OK" key. Refer to Illustration 3
When you press the "OK" button, you can edit the on-grade tolerance using the up and down arrow buttons. Press the "OK" key to accept. Sound Setup
Illustration 10 g02211078The grade control sound setup dialog lets the operator configure the display beeper behavior as applicable to Cat Grade Control.The only options for each item are "YES" or "NO". Operator uses the standard method of editing this type of field.Note: When the bucket tip is 4 times the tolerance away from grade, the alarm turns off.Grade Unit Select
Illustration 11 g02221153In the Grade Units dialog, you can define the grade units for the system from the following options:
Ratio
Percentage
DegreesNote: The length/distance units are a global setting and are configured from the "Main Display Settings" menu and shared across all other functions of the display.Linkage Elevation Monitor Setup
Failure to set elevation limit measurements may cause serious injury or death. Failure to react to the visual and audible elevation monitor alerts may cause serious injury or death.The operator must set elevation limit measurements and react to visual and audible elevation monitor alerts by stopping the linkage as the audible and visual notifications occur.
Under the Cat Grade Control menu, the user can configure the system to provide linkage elevation monitor guidance.Within the "Linkage Elevation Monitor Setup" dialog, the user is able to enable ceiling, floor or both. Depending on which linkage elevation monitor is enabled determines which linkage elevation monitor status icons are displayed on the Cat Grade Control guidance screen.
Cat Grade Control is enabled,