SPIDER & BEARING GP 2355201 - Caterpillar

Assembly Procedure
Verify that all of the components are clean and free of foreign material prior to installation. Check all of the O-ring seals and the components for wear or damage. Replace the O-ring seals and the components, if necessary.
Lubricate all of the O-ring seals lightly with the lubricant that is being sealed.
Illustration 1 g00525187
Illustration 2 g00525186
Install union (25) and the O-ring seal (not shown) to valve (1). Install nipple (24) and the O-ring seal to union (25). Install cap (22) onto nipple (24) .
Install fluid sampling valve (23) and the O-ring seal into valve (1) .
Illustration 3 g00525146
Install orifice plug (21) into valve (1) .
Illustration 4 g00525144
Install O-ring seal (20) onto valve body (16) .
Install valve (15) and plate (19) into valve body (16) .
Install O-ring seal (13) onto retainer (17) .
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install spring (14) and hard washer (18) into valve body (16). Install retainer (17) onto valve body (16).
Install nut (12) onto retainer (17). Tighten nut (12) to a torque of 50 7 N m (37 5 lb ft).
Illustration 5 g00525137
Install O-ring seal (11) into relief valve (10). Install relief valve (10) into valve (1). Tighten relief valve (10) to a torque of 65 5 N m (47.9 3.7 lb ft).
Illustration 6 g00525129
Install O-ring seal (9) onto check valve (8) .
Illustration 7 g00525128
Install check valve (8) into valve (1). Install O-ring seal (7) onto check valve (8) .
Illustration 8 g00525125
Install O-ring seal (5), O-ring seal (6) and the backup ring onto cartridge assembly (3) .
Illustration 9 g00525235
Illustration 10 g00525116
Install cartridge assembly (3) into valve (1). Tighten cartridge assembly (3) to a torque of 169 7 N m (124.7 5.2 lb ft).
Install coil assembly (4) into cartridge assembly (3). Position coil assembly (4), as shown. Install locknut (2) and the washer onto cartridge assembly (3). Tighten locknut (2) to a torque of 9 .5 N m (79.7 4.4 lb in).
Illustration 11 g00623330
Install the elbow and install the caps and plugs to valve (1) .End By: Install the steering solenoid and relief valve. Refer to Disassembly and Assembly, "Solenoid and Relief Valve (Steering) - Install".