SPIDER-BRG-YM 3676069 - Caterpillar

Illustration 1 g00778120
Schematic of the Position Sensor for the Service Brake Pedal Note: The sensor does not connect directly to the frame ground. The sensor connects to the return circuit of the ECM. The ECM internally connects the return wire to frame ground.This diagnostic code is recorded when the ECM detects the signal of the sensor as being out of calibration.In order to correct this diagnostic code, calibrate the sensor. Perform the calibration procedure for the center pedal sensor. See Testing and Adjusting, "Calibration" for more information.Test Step 1. CALIBRATION
Perform the calibration procedure for the center pedal sensor.Expected Result:The calibration procedure was performed successfully.Results:
YES - The calibration procedure was performed successfully. Resume normal machine operation.STOP
NO - The calibration was not successful.Repair: Perform the calibration procedure for the center pedal sensor again.STOP