SPIDER & BEARING AS 5079442 - Caterpillar

Illustration 1 g01149233
(1) 5M-2894 Hard Washer (2) 0S-1571 Bolt (3) Coolant bypass tube (4) Elbow (5) 108-6170 Clamp As (6) 0S-1594 Bolt (7) 9S-8752 Full Nut (8) 6V-5066 O-Ring Seal (9) 110-0096 Ring
Install O-ring seal (8) and ring (9) onto coolant bypass tube (3). Assemble clamps (5) onto bypass tube (3). In order to fasten the clamps, install the following components: bolts (6), washers (1) and nuts (7). Tighten the bolts so that the clamps remain in place on the tube.
Align the boss of clamp (5) with the bolt holes of elbow (4). Install two bolts (2) and two washers (1) onto the elbow. Tighten the bolts to 47 9 N m (35 7 lb ft).
Tighten bolts (6) and nuts (7) to 47 9 N m (35 7 lb ft).
Illustration 2 g01033375
Typical example (1) ClampsTable 1 lists the water lines groups that are affected by the use of the clamp. Table 2 lists the parts that were added and the parts that were removed within the water lines groups.
Table 1
Water Lines Group    
7W-0486 Water Lines    
107-8765 Water Lines    
167-9555 Water Lines    
178-6403 Water Lines    
137-8221 Water Lines    
9Y-8928 Water Lines    
178-6382 Water Lines    
209-5263 Water Lines    
161-1555 Water Lines    
112-6020 Water Lines    
137-8227 Water Lines    
217-7030 Water Lines    
Table 2
Added Parts     Removed Parts    
108-6170 Clamp As     8N-3639 Retainer    
0S-1571 Bolt     8N-3640 Retaining Ring    
5M-2894 Hard Washer        
9S-8752 Full Nut        
110-0096 Ring