SPIDER AND BEARING ASSEM. 6M9762 - Caterpillar

Disconnect hose (9) from the pump neutralizer manifold.
Install Tool (E) in hose (9) .
Cap the port with Tool (F) .
Connect Tool (A) to Tool (E) .
Disconnect hose (10) from the pump neutralizer manifold.
Install Tool (E) in hose (10) .
Cap the port with Tool (F) .
Connect Tool (A) to Tool (E) .
Illustration 5 g01244148
Disconnect hose (11) .
Plug hose (11) with Tool (H), and cap the port with Tool (J) .
Move engine start switch (3) to the START position. Release the switch when the engine starts.
Operate the engine at low idle for a few minutes. Move throttle control lever (4) to the number two HIGH IDLE position.
Monitor the hydraulic oil temperature with Tool (D). Operate the machine until the oil temperature reaches 43° 5.6°C (110° 10°F).
Illustration 6 g01244149
Move propulsion enable lever (12) into the ENABLE position.
Move parking brake switch (2) into the OFF position.
Move propel lever (1) into the FORWARD range, approximately one-half the distance to the maximum position.
Record the pressure on Tool (A) that is in hose (9). Record the pressure on Tool (A) that is in hose (10) .
Move propel lever (1) into the NEUTRAL position.
Move parking brake switch (2) into the ON position.
Move propel enable lever (12) into the DISABLE position.
Move throttle control lever (4) to the LOW IDLE position.
Move key switch (3) to the OFF position.
If the two pressure readings recorded in Step 26 are equal,