SPIDER & BEARING AS 6S6902 - Caterpillar

Diagnostic Codes
Diagnostic codes alert the operator that a problem in the electronic system has been detected. Diagnostic codes are also used to alert the operator that abnormal operating conditions, such as low oil pressure or high coolant temperature, have been detected. For information that is related to the trip point and delay time settings for these codes, refer to Troubleshooting, "Engine Monitoring Parameters".Diagnostic codes are used by the service technician to identify the nature of the problem. The technician must have access to a diagnostic tool to read diagnostic information.CAN Data Link
The CAN data link is used by the Electronic Control Module (ECM) to communicate with control modules, display modules, and service tools. The CAN data link is referred to as the J1939 data link. When a diagnostic code is activated, the ECM can transmit information about the diagnostic code over the J1939 data link to these devices. The diagnostic code will be displayed as a two-element code. The following terms describe the elements of the code:Suspect Parameter Number (SPN) - The SPN is a code which is assigned to each component to identify data via the data link to the ECM.Failure Mode Identifier (FMI) - The FMI indicates the type of failure.Refer to Table 1 for a complete list of the diagnostic codes and the appropriate troubleshooting procedure.Information for Diagnostic Codes
Table 1 is a list of the diagnostic codes for the engine. The diagnostic codes are cross-referenced with the appropriate procedure that can be used to troubleshoot the code.Cross-Reference from the J1939 Code to the Appropriate Circuit Test
Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.
Table 1
Cross-Reference from J1939 Code to the Appropriate Troubleshooting Procedure
J1939 Code and Description Troubleshooting Procedure
29-2 Accelerator Pedal Position 2 : Erratic, Intermittent, or Incorrect Troubleshooting, "Sensor Signal (PWM) - Test"
29-3 Accelerator Pedal Position 2 : Voltage Above Normal Troubleshooting, "Sensor Signal (PWM) - Test"
29-4 Accelerator Pedal Position 2 : Voltage Below Normal Troubleshooting, "Sensor Signal (PWM) - Test"
29-8 Accelerator Pedal Position 2 : Abnormal Frequency, Pulse Width, or Period Troubleshooting, "Sensor Signal (PWM) - Test"
91-2 Accelerator Pedal Position 1 : Erratic, Intermittent, or Incorrect Troubleshooting, "Sensor Signal (PWM) - Test"
91-3 Accelerator Pedal Position 1 : Voltage Above Normal Troubleshooting, "Sensor Signal (PWM) - Test"
91-4 Accelerator Pedal Position 1 : Voltage Below Normal Troubleshooting, "Sensor Signal (PWM) - Test"
91-8 Accelerator Pedal Position 1 : Abnormal Frequency, Pulse Width, or Period Troubleshooting, "Sensor Signal (PWM) - Test"
100-1 Engine Oil Pressure : Low - most severe (3) Troubleshooting, "Oil Pressure Is Low"
100-3 Engine Oil Pressure : Voltage Above Normal Troubleshooting, "Sensor Signal (Analog, Active) - Test"
100-4 Engine