7C0876 SPIDER AS-FAN Caterpillar parts
446B, 446D, RT100
Rating:
Alternative (cross code) number:
CA7C0876
7C-0876
7C0876
CA7C0876
7C-0876
7C0876
Weight: 6 pounds 3 kg.
Information:
BLADE WIDTH
64.4
mm
BOLT CIRCLE DIAMETER
88.9
mm
DIAMETER OF PITCH CIRCLE HOLES
9
mm
HUB THICKNESS
8.5
mm
NUMBER OF BLADES
6
NUMBER OF PITCH HOLES
6
OD
533.4
mm
PILOT HOLE DIAMETER
65.12
mm
TYPE
SUCTION
BACKHOE LOADER, TELEHANDLER,
Information:
Illustration 1 g03097016
Schematic of the Engine Speed Dial SwitchThis diagnostic code is associated with the engine speed dial switch. The FMI 05 means that the ECM has determined that the current of the switch is below normal. The possible causes of this diagnostic code are listed:
The circuit of the switch is open.
The switch has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0586 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE SWITCH.
Turn the disconnect switch and the key start switch to the OFF position. Do not start the engine.
Disconnect the engine speed dial switch from the machine harness.
Use the following table for the rotary dial position and check the corresponding resistance for the switch.
Table 1
Rotary Dial Position     Check the Resistance Between the Following Contacts on the Switch.    
1     Contact (1)
to
Contact (2)    
3     Contact (1)
to
Contact (3)    
7     Contact (1)
to
Contact (4)    
10     Contact (1)
to
Contact (5)    Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The switch is correct. Proceed to Test Step 2.
NOT OK - The resistance is greater than 5 ohms. The resistance measurement is not correct. There is an open circuit in the switch.Repair: Replace the switch.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
Use the following table for the placement of a jumper wire to the connector for the switch and check the corresponding resistance for the contacts of the machine harness connector(s).
Table 2
Jumper Location on the Connector for the Switch     Connector(s) for the Machine Harness    
Contact (1)
to
Contact (2)     Contact J1-9 (wire A755-PK) and contact J1-14 (wire 235-BK) of the machine harness.    
Contact (1)
to
Contact (3)     Contact J1-10 (wire A756-BU) and contact J1-14 (wire 235-BK) of the machine harness.    
Contact (1)
to
Contact (4)     Contact J1-19 (wire A757-GY) and contact J1-14 (wire 235-BK) of the machine harness.    
Contact (1)
to
Contact (5)     Contact J1-20 (wire A758-BR) and contact J1-14 (wire 235-BK) of the machine harness.    Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0586
Caterpillar parts catalog:
Parts spider Caterpillar catalog:
0542213
SPIDER & BEARING AS
416, 416B, 424B, 424B HD, 426, 426B, 428, 428B, 436, 436B, 438, 438B, 446, 446B, 902, 906, 908, CS-323, PR-1000, RR-250
416, 416B, 424B, 424B HD, 426, 426B, 428, 428B, 436, 436B, 438, 438B, 446, 446B, 902, 906, 908, CS-323, PR-1000, RR-250
9R2491
SPIDER
416, 416B, 416C, 416D, 420D, 424D, 426, 426B, 426C, 428, 428B, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D, 446, 446B, 446D, CP-563, CS-533, CS-533C, CS-533D, CS-563C
416, 416B, 416C, 416D, 420D, 424D, 426, 426B, 426C, 428, 428B, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D, 446, 446B, 446D, CP-563, CS-533, CS-533C, CS-533D, CS-563C
9R6993
SPIDER
446, 446B, M312, M313C, M315, M315C, M316C, M318, M318C
446, 446B, M312, M313C, M315, M315C, M316C, M318, M318C
9R2994
SPIDER AS
446, 446B, 446D, 525B, 525C, 535B, 535C, 545, 545C
446, 446B, 446D, 525B, 525C, 535B, 535C, 545, 545C
9R2491
SPIDER
416, 416B, 416C, 416D, 420D, 424D, 426, 426B, 426C, 428, 428B, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D, 446, 446B, 446D, CP-563, CS-533, CS-533C, CS-533D, CS-563C
416, 416B, 416C, 416D, 420D, 424D, 426, 426B, 426C, 428, 428B, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D, 446, 446B, 446D, CP-563, CS-533, CS-533C, CS-533D, CS-563C
9R8715
SPIDER & BEARING AS
416, 416B, 426, 426B, 428, 428B, 436B
416, 416B, 426, 426B, 428, 428B, 436B
4P3383
SPIDER AS-FAN
416B, 428B
416B, 428B
6I2852
SPIDER AS-FAN
416B, 426B, 428B, 438B
416B, 426B, 428B, 438B
9L5958
SPIDER AS-FAN
3126B, 3304, 3306, 3406, 3406B, C-9, C7, C9, CX31-C9I, TH31-E61
3126B, 3304, 3306, 3406, 3406B, C-9, C7, C9, CX31-C9I, TH31-E61
9N2332
SPIDER AS
3304, 3306, 3406B, 3406C, 3408, D250E, D250E II, D25C, D25D, D300B, D300D, D300E, D300E II, D30C, D350C, D35C
3304, 3306, 3406B, 3406C, 3408, D250E, D250E II, D25C, D25D, D300B, D300D, D300E, D300E II, D30C, D350C, D35C
7N7313
SPIDER AS-FAN
3176B, 3176C, 3196, 611, 615, 615C, 637D, 65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E, C-10, C-12, C11, C13, CX31-C13I, TH35-C11I, TH35-C13I
3176B, 3176C, 3196, 611, 615, 615C, 637D, 65, 65C, 65E, 75C, 75D, 75E, 85C, 85D, 85E, 95E, C-10, C-12, C11, C13, CX31-C13I, TH35-C11I, TH35-C13I
9P0356
SPIDER & BEARING AS
120H, 120H ES, 120H NA, 120K, 120K 2, 12H, 12H ES, 12H NA, 12K, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, 163H NA, 16G, 16H, 16H NA, 3...
120H, 120H ES, 120H NA, 120K, 120K 2, 12H, 12H ES, 12H NA, 12K, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 14H, 14H NA, 160H, 160H ES, 160H NA, 160K, 163H, 163H NA, 16G, 16H, 16H NA, 3...
1295450
SPIDER AS-FAN
35, 45, 55
35, 45, 55
9R2994
SPIDER AS
446, 446B, 446D, 525B, 525C, 535B, 535C, 545, 545C
446, 446B, 446D, 525B, 525C, 535B, 535C, 545, 545C
9R6993
SPIDER
446, 446B, M312, M313C, M315, M315C, M316C, M318, M318C
446, 446B, M312, M313C, M315, M315C, M316C, M318, M318C