SPIDER AS 7C7464 - Caterpillar

Illustration 1 g01362926
Illustration 2 g01404462
Illustration 3 g01362927
Engage the parking brake.
Refer to the illustrations 1, 2, and 3 in order to place the machine in the service position.
Refer to the illustrations 1, 2, and 3 in order to make sure that the stabilizers and the dozer blade (if equipped) are in the fully raised position.
Stop the engine and remove the key.
Wait for 5 minutes in order to allow the hydraulic oil to stabilize before checking hydraulic oil level.
Open the right rear access cover that is located in the engine compartment on the right side of the machine.
Illustration 4 g00803536
Note: The glass gauge contains three rings for level markers. Maintain the oil level between the bottom ring and the center ring for a cold machine, and between the center ring and the top ring for a machine at normal operating temperature.
If the level is low, please read the introduction "Fill the hydraulic tank".
Close the right rear access door.