SPIDER & BEARING ASSEM. 8K7002 - Caterpillar

Harness Wire Identification
Caterpillar identifies different wires with eleven different solid colors. Table 1 lists the color codes of the wiring.
Table 1
Color Codes for Wiring
Code Color
BK Black
BR Brown
BU Blue
GN Green
GY Gray
OR Orange
PK Pink
PU Purple
RD Red
WH White
YL Yellow In addition to the color, the entire length of each wire is stamped with a specific circuit number that is repeated on every 25 mm (1 inch) of the wire. The actual wires are identified on the schematic.For example, a code of J011-RD on the schematic identifies a red wire that is stamped with the circuit number J011. This particular wire is the engine harness wire for the primary signal of the transformer in the number one cylinder. For all Caterpillar engine harnesses with electronic ignition systems, the code of J011-RD identifies the wire for the primary signal of the transformer in the number one cylinder.The schematic also identifies the size of the wire. The size or gauge of the wire is called the American Wire Gauge (AWG). Unless the schematic specifies a different size, you may assume that the wire is 16 AWG.Terminal Box
Illustration 1 g01329087
Rear view
(1) Terminal box The terminal box contains the Electronic Control Module (ECM). The electrical connectors for the terminal box are located between the terminal box and the engine.The two possible configurations for the control system are with the optional Auxiliary Sensing Module (ASM) and without the optional ASM.
Illustration 2 g01524441
Rear view
This view is with the optional Auxiliary Sensing Module (ASM). The cover of terminal box (1) is not shown.
(2) Terminal box
(3) ECM
(4) P2 connector
(5) P1 connector
(6) Panel light switch
(7) ASM
(8) P3 connector
(9) J7 connector for the main wiring group
(10) J8 connector for the detonation sensors
(11) J9 connector for the ASM
(12) J6 connector for the customer
(13) Connector for the service tool
(14) Emergency stop button (typical location)
(15) Connector for the left side ignition
(16) Connector for the right side ignition
(17) Integrated Temperature Sensing Module (ITSM)
Illustration 3 g01524442
Rear view
This view is without the optional Auxiliary Sensing Module (ASM). The cover of terminal box (1) is not shown.
(18) Terminal box
(19) ECM
(20) Ground strap for the ECM
(21) P2 connector
(22) P1 connector
(23) Harness for the ignition circuits
(24) J10/P10 connector for the terminating resistor for the CAN data link
(25) J5 connector for the service tool
(26) P6 connector for the customer
(27) P9 connector for the ITSM
(28) P7 connector for the main wiring group
(29) P8 connector for the detonation sensors Junction Box
Illustration 4 g01524443
The junction box is located on left side of the engine.
(30) Junction box
(31) 2.5 amp circuit breaker for the engine control
(32) 10 amp circuit breaker for the customer
(33) 35 amp circuit breaker for the engine
(34) 2.5 amp circuit breaker for the start command from the ECM
(35) Positive terminal for the connection of the engine's power supply
(36) Negative terminal for the connection of the engine's power supply The junction box contains all of the circuit breakers for the engine. The junction box also contains the magnetic switches for the electric starting motors.The mounting of the power distribution box and the routing of the wiring within the box