SPIDER & BEARING AS 8R7752 - Caterpillar

Illustration 1 g02639057
Table 1
Specification for 7E-8996 Flywheel Housing Gp
Item Qty Part Specification Description
Before installation of the flywheel housing, inspect the following components for any foreign materials: The front face of the flywheel housing, the two sides of the flywheel housing gasket and the rear face of the cylinder block. These components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign material. Apply ultra blue Loctite 587 as a continuous film on entire joint face.
1 8 9K-7290 Bolt Use the following procedure to tighten the flywheel housing bolts:
1.Tighten the bolt 1 through bolt 9 to 100 20 N m (75 15 lb ft) in the numerical sequence.
2. Tighten the bolt 10 through bolt 22 to 40 10 N m (30 7 lb ft) in the numerical sequence.
3. Again, tighten the bolt 1 through bolt 9 to 135 20 N m (100 15 lb ft) in the numerical sequence.
4. Again, tighten the bolt 10 through bolt 22 to 55 10 N m (41 7 lb ft) in the numerical sequence.
2 1 5J-5793 Bolt
3 6 165-3932 Bolt
4 1 165-3936 Bolt
5 6 165-3930 Bolt