SPILL PLATE EXTENSION GROUP 2K4831 - Caterpillar

To avoid injury do not stand on or between implement and machine while operating lift control.
General Information Section
Introduction
Illustration 3 g03886523The Lifting Device is designed to lift C175 Front Gear Groups into the 291-1998 Pump Assembly Adaptoror 354-1562 for removal, service, and installation. It is used with a suitable overhead lifting device that can lift the gear group safely into the Pump Assembly Adaptor.Specifications
Illustration 4 g03886528
Table 1
469-7628 C175 Front Gear Cluster Lifting Device
Item Description Specifications
A Height 350 mm (13.78 inch)
B Diameter 25 mm (0.98 inch)
-- Weight 1.0 kg (2.20 lbs)
-- Working Load Limit (WLL) 90.91 kg (200 lbs) Nomenclature
Illustration 5 g03886546
Table 2
469-7628 C175 Front Gear Cluster Lifting Device
Item Description Qty
1 Eyebolt Assembly Lift 1
2 Lifting Rod 1
3 Protecting Tube 1
4 Lifting Disc 1 Operation Section
Operation
Illustration 6 g03886553
Inspect 469-7628 Lifting Device before each use. Do not use any tool that is damaged, altered, or in poor condition.Note: For more information on specific C175 gear cluster disassembly and assembly, refer to the appropriate manual for the vehicle being serviced.
Insert Lifting Rod (2) into the Front Gear Cluster Assembly (figure 1). Once Lifting Rod is in the assembly, attach the Lifting Disc (4) to the end of the Lifting Rod (figure 2).
Use overhead lifting device to lift attached front gear clusters to desired location.Maintenance
Inspection
Inspect prior to each use for nicks, burrs, dents, cracks, bends, or worn parts. If damage is found, discontinue use until inspected and released for use by an approved inspector at the dealership.
Have tools inspected annually by an approved dealership inspector. Maintain a written record of all inspections.
Make sure eyebolt assembly lift (1) is fully attached and screwed into the lifting rod (2).
Make sure bottom of lifting rod where lifting disc attaches has no signs of damage, cracks, bends, or other deformities.
Make sure lifting disc (4) has no signs of damage, cracks, bends, or other deformities in the plastic.
Illustration 7 g03716280
Do not use if Working Load Limit (WLL) markings are not legible.Service Parts
Illustration 8 g03886554
Table 3
469-7628 C175 Front Gear Cluster Lifting Device
Service Parts
Item Part No Description Qty
1 395-1099 Eyebolt Assembly Lift 1
2 469-7629 Lifting Disc 1 Cleaning
Clean the tooling using a non-solvent based cleaner.Storage
Store the tooling indoors in a clean, dry location to prevent rust or corrosion. Tooling can be damaged by moisture or high humidity.The tool should be stored in the most stable position.Tool Disposal
At the end of the operational life of the tool, destroy the tool, and dispose of as scrap.