AVSPARE.COM
parts catalog

SPINDLE-WHEEL 1473312 - Caterpillar


1473312 SPINDLE-WHEEL Caterpillar parts 16G, 16H, 16H NA
Rating:
11
Alternative (cross code) number:
CA1473312
147-3312
1473312
Caterpillar 1473312 SPINDLE-WHEEL
Weight: 225 pounds 102 kg.

Buy SPINDLE-WHEEL 1473312 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
$2,270.39
 

26 Oct 2023

US: Florida-Parts-Z
1473312INDLE-WHEEL 6G8204 9D1223 fit CATERPILLAR (CAT)
FIRST PRICE PARTS
$2,270.39
 

27 Sep 2023

US: Florida-Parts-Z
1473312INDLE-WHEEL 6G8204 9D1223 fit Caterpillar (CAT)
FIRST PRICE PARTS
$2,270.29
 

26 Aug 2018

CATERPILLAR AFTERMARKET: CATERPILLAR AFT
Caterpillar Spindle 1473312 New
Number on catalog scheme: 24
  For full view, you need register

Compatible equipment models: 1473312:

MOTOR GRADER  16G   16H   16H NA   Caterpillar

Information:

This procedure covers the following diagnostic code:Note: This procedure is applicable to engines equipped with a wall flow DPF only.
Table 1
Diagnostic Trouble Codes for Diesel Particulate Filter (DPF) Collects Excessive Soot
J1939 Code Description Notes
3251-16 Particulate Trap Differential Pressure : High - moderate severity (2) The Electronic Control Module (ECM) detects the following conditions:
The differential pressure across the DPF is high for at least 100 seconds. The pressure at which this code becomes active is dependent on the level of soot indicated by the soot model that is calculated by the ECM.
The battery voltage is at least 10 VDC.
If equipped, the warning lamp will flash. The engine will be derated.
3251-0 Particulate Trap Differential Pressure : High - most severe (3) The Electronic Control Module (ECM) detects the following conditions:
The differential pressure across the DPF is very high for at least 100 seconds. The pressure at which this code becomes active is dependent on the level of soot indicated by the soot model that is calculated by the ECM.
The battery voltage is at least 10 VDC.
If equipped, the warning lamp will flash and the shutdown lamp will come on.
3719-0 Aftertreatment 1 Diesel Particulate Filter Soot Load Percent : High - most severe (3) The ECM detects that the soot level in the DPF is high.
The warning lamp will come on.
3719-16 Aftertreatment 1 Diesel Particulate Filter Soot Load Percent : High - moderate severity (2) The ECM detects that the soot load in the DPF is very high.
The warning lamp will flash. The engine may be derated. The Electronic Control Module (ECM) uses the Diesel Particulate Filter (DPF) differential pressure sensor to monitor the soot load in the DPF. An excessive accumulation of soot in the DPF can be caused by the following faults:Probable Causes
Faulty injectors
Incorrect Wiring for Temperature Sensors
Individual malfunctioning cylinders
Low exhaust gas temperature
A faulty valve in the NOx Reduction System (NRS)Recommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in order.Note: Engine operation must be kept to a minimum in order to minimize the amount of soot that is created. Follow the troubleshooting procedure in order to minimize the amount of engine operation.
Table 2
Troubleshooting Test Steps Values Results
1. Diagnostic Codes
A. Establish communication between the electronic service tool and the Electronic Control Module (ECM).
B. Check for active diagnostic codes. Check specifically for codes that relate to the "Probable Causes" in this procedure.
Diagnostic codes
Result: A diagnostic trouble code is active or logged.
Repair: Troubleshoot any related diagnostic codes before continuing with this procedure.
Result: A related diagnostic trouble code is not active or logged.
Proceed to Test Step 2.
2. Incorrect Wiring for Temperature Sensors
A. Check that the Diesel Oxidation Catalyst (DOC) inlet temperature sensor and DPF inlet temperature sensor wiring has not been switched.
Note: The engine may run without indicating a fault for many hours with this condition.
B. Check that the wiring

Caterpillar parts catalog:

Caterpillar parts catalog
16G Motor Grader 93U02679-UP (MACHINE) POWERED BY 3406 Engine
16H Motor Grader 6ZJ00001-UP (MACHINE) POWERED BY 3406C Engine
16H Motor Grader ATS00001-UP (MACHINE) POWERED BY 3196 Engine


Parts spindle Caterpillar catalog:

1473311 SPINDLE-WHEEL
14G, 14H, 14H NA
8W2357 SPINDLE-FRONT AXLE
120G, 12G, 130G, 140G
1473310 SPINDLE-WHEEL
12G, 12H, 12H ES, 12H NA, 12K, 130G, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 160G, 160H, 160H ES, 160H NA, 160K, 163H, 163H NA
1473309 SPINDLE-WHEEL
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 135H, 135H NA
1473400 SPINDLE
120H, 120H ES, 120H NA, 120K, 120K 2, 12H, 12H ES, 12H NA, 12K, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 160H, 160H ES, 160H NA, 160K
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.