SPINDLE 1582458 - Caterpillar

Illustration 16 g01065304
Remove plate (4) from the housing.
Illustration 17 g01064967
Use Tooling (A) in order to remove retaining ring (5).
Illustration 18 g01064968
Protect the shaft. Use shrink wrap or electrical tape. Remove cover (6).
Illustration 19 g01064970
Remove O-ring seal (8) and shims (9) from the housing.
Illustration 20 g03431108
Use Tooling (A) to remove rotating group (10) from housing (11). Do not allow the barrel to separate from the pistons during the removal procedure.
Illustration 21 g00835428
Remove barrel (12) from the pistons.
Illustration 22 g00836318
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Remove spring (13) from barrel (12).
Illustration 23 g00835431
Install shim (14) that was determined in Step 17. Install spring (13) into barrel (12).
Illustration 24 g00835428
Install barrel (12) onto the pistons.
Illustration 25 g01065300
Raise the temperature of housing (11) to 80 °C (176 °F). Lower the temperature of rotating group (10).
Install rotating group (10) into housing (11). Do not allow the barrel to separate from the pistons during the installation procedure.
Illustration 26 g01064970
Install shims (9) and O-ring seal (8) into the housing.
Illustration 27 g01064968
Install cover (6).
Illustration 28 g01064967
Install retaining ring (5).
Illustration 29 g01064965
Install O-ring seal (3) and plate (4).
Illustration 30 g01064963
Position head (2).
Install bolts (1). End By:
Install the piston motor.