SPINDLE 1914921 - Caterpillar

(1) Torque for locknut for rocker arm adjustment screw ... 70 15 N m (50 11 lb. ft.)(2) Diameter of rocker arm shaft ... 37.084 0.013 mm (1.4600 .0005 in.) Bore in bearing for rocker arm shaft ... 37.140 0.015 mm (1.4622 .0006 in.)(3) Injector installation: a. Put multipurpose grease in bore of cylinder head for lubrication of the O-Ring seals.b. Put injector in bore. Use bolt and clamp to push injector into the correct position. Do not tap (hit) surface "Y" to install injector.c. Tighten bolt that holds fuel injector clamp to ... 65 7 N m (48 5 lb. ft.)d. After clamp is tightened, injector rack "X" must move freely.(4) Fuel timing dimension set by gauge. For the correct dimension to use, see the ENGINE INFORMATION PLATE.(5) Guide springs must not be used again. Always install new guide springs.(6) Diameter of valve lifter (new) ... 29.900 0.010 mm (1.1772 .0004 in.) Bore in head for valve lifter ... 30.000 0.025 mm (1.1811 .0010 in.)