SPOOL AS- 2441764 - Caterpillar

Table 1
Required Tools
Part Number Description Quantity
JEBD3003 Caterpillar Electronic Technician (Cat ET) 1
317-7485 Communication Adapter-3 As 1
327-8981 Adapter Cable As
(CA3 to Service Tool) 1
370-4617 Adapter Cable As
(CA3 to PC USB) 1
317-7484 Communication Adapter-3 Kit
(Incl. Communication Adapter-3 As, two Cables listed above) 1 The Caterpillar Electronic Technician (Cat ET) is used to access the configuration screen . A message on the Cat ET screen will give instructions that guide the user through the procedure. Refer to the manual that is provided with the Cat ET software for more information about Cat ET.The Electronic Control Module (ECM) must be configured when the ECM has been replaced. The ECM must be configured before a calibration can be started.A check of the configuration screen could resolve a problem with the machine. A problem with a component could be identified as one of the following items:
A component is not installed.
A component is installed, but a change to the installation is needed in order to correct a problem.Follow these instructions to get to the configuration screen:
Connect the communications adapter and the computer to the diagnostic service tool connector.
Start the Caterpillar Electronic Technician (Cat ET).
Select "File". Go to "Select ECM". Choose the appropriate ECM.
Go to the "Service" Menu. Select "Configurations". Click "OK". Certain operations or characteristics can be changed.