AVSPARE.COM
parts catalog

SPOOL ASSEM. 3P5834 - Caterpillar


3P5834 SPOOL ASSEM. Caterpillar parts D7G
Rating:
20
Alternative (cross code) number:
CA3P5834
3P-5834
3P5834
Caterpillar 3P5834 SPOOL ASSEM.
Weight: 102 pounds 46 kg.

Buy SPOOL ASSEM. 3P5834 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compatible equipment models: 3P5834:

TRACK-TYPE TRACTOR  D7G   Caterpillar
Number on catalog scheme: None
  For full view, you need register

Information:


Illustration 2 g01209797
Terminals at the P1 ECM connectors that are associated with the CAN data link (P1-34) CAN data link − (P1-42) CAN shield (P1-50) CAN data link +
Illustration 3 g01360095
Terminals at the engine interface connector that are associated with the CAN data link (P1-16) CAN shield (P1-17) CAN data link + (P1-18) CAN data link −
Illustration 4 g01209794
Terminals at the service tool connector that are associated with the CAN data link (Terminal C) CAN shield (Terminal F) CAN data link + (Terminal G) CAN data link −
Illustration 5 g01355248
Terminals at the connector for the termination resistor that are associated with the CAN data link (Terminal A) CAN data link + (Terminal B) CAN data link − (Terminal C) CAN shield
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the CAN data link.
Check the allen head screw on each ECM connector and on the engine interface connector for the proper torque. Refer to Troubleshooting, "Electrical Connectors - Inspect" for the correct torque values.
Check the wiring harnesses for abrasion, for corrosion and for pinch points.Expected Result:All connectors, pins and sockets are completely coupled and/or inserted. The harness and wiring are free of corrosion, of abrasion and of pinch points.Results:
OK - The harness and wiring appear to be OK. Proceed to Test Step 2.
Not OK - There is a problem in the wiring harness.Repair: Repair the connectors and/or the wiring. Replace parts, if necessary. Ensure that all of the seals are properly in place and ensure that the connectors are completely coupled. Verify that the problem is resolved.STOPTest Step 2. Verify the Proper Installation of the Termination Resistors
Disconnect the display panel from the data link.
Disconnect Caterpillar Electronic Technician (ET) from the service tool connector.
Disconnect the P1 connector from the primary ECM and from the secondary ECM.Note: Wiggle the harness during the following measurements in order to reveal an intermittent condition.
Measure the resistance between terminals P1-50 (CAN Data Link +) and P1-34 (CAN Data Link -).Expected Result:The resistance is between 57 and 63 Ohms.Results:
OK - The resistance is between 57 and 63 Ohms. Proceed to Test Step 3.
Not OK - The resistance is between 114 Ohms and 126 Ohms. A termination resistor is missing.Repair: Verify that two termination resistors are connected to the data link. One resistor must be located on each end of the data link. The engine is shipped with one termination resistor that is installed between the ECM and the engine interface connector.Refer to the appropriate electrical schematic in order to determine the missing resistor. Replace the missing resistor. Verify that the problem is resolved.STOP
Not OK - The resistance is less than 57 Ohms. There may be a short circuit in the harness. Proceed to Test Step 3.
Not OK - The resistance is greater than 126 Ohms. There may be an open circuit in the harness. Proceed to Test Step 4.Test Step 3. Check the Harness for a Short Circuit
Remove both termination resistors from the CAN data link.
Disconnect the display panel.
Measure the resistance between

Caterpillar parts catalog:

Caterpillar parts catalog
D7G TRACTOR / POWERSHIFT / 92V00001-02126 (MACHINE)
572G PIPELAYER 40U00001-00410 (MACHINE)
571G PIPELAYER 16W00001-00255 (MACHINE)
D7G LGP TRACTOR 72W00001-00607 (MACHINE) POWERED BY 3306 ENGINE
D7G TRACTOR / POWERSHIFT / 92V02127-11897 (MACHINE) POWERED BY 3306 ENGINE
572G PIPELAYER 16W00256-UP (MACHINE)
572G PIPELAYER 40U00411-00970 (MACHINE) POWERED BY 3306 ENGINE
D7F TRACTOR 94N05192-UP (MACHINE)
D7G TRACTOR / POWERSHIFT / 92V00001-02126 (MACHINE)
572G PIPELAYER 40U00001-00410 (MACHINE)
571G PIPELAYER 16W00001-00255 (MACHINE)
D7G LGP TRACTOR 72W00001-00607 (MACHINE) POWERED BY 3306 ENGINE
D7G TRACTOR / POWERSHIFT / 92V02127-11897 (MACHINE) POWERED BY 3306 ENGINE
572G PIPELAYER 16W00256-UP (MACHINE)
572G PIPELAYER 40U00411-00970 (MACHINE) POWERED BY 3306 ENGINE
D7F TRACTOR 94N05192-UP (MACHINE)
D7G TRACTOR POWERSHIFT 65V07701-UP (MACHINE) POWERED BY 3306 ENGINE
D7G TRACK-TYPE TRACTOR / POWER SHIFT / 65V00001-03400 (MACHINE) POWERED BY 3306 ENGINE
D7G LGP TRACTOR / POWERSHIFT / 44W00001-UP (MACHINE) POWERED BY 3306 ENGINE


Parts spool Caterpillar catalog:

4N6407 SPOOL-DASHPOT
120G, 120H, 120H ES, 120H NA, 12G, 12H, 12H ES, 12H NA, 130G, 135H, 135H NA, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 16G, 16H NA, 211B, 214B, 215,...
3P4660 SPOOL-VALVE
55, 578, D10N, D10R, D4H, D4H XL, D4HTSK II, D4HTSK III, D5H, D5H XL, D5HTSK II, D6D, D6H, D6H XL, D6H XR, D7G, D7H, D7R, D8R
9M2025 SPOOL-REDUCING
572G, 977K, D6C, D6D, D6E, D6G2 LGP, D6G2 XL, D7G, D7G2
6P4711 SPOOL AS-DIFFERENTIAL
572G, 977K, D5, D5B, D6C, D6D, D6E, D6G2 LGP, D6G2 XL, D7G, D7G2
1K8362 SPOOL-VALVE
572G, 621, 631C, 650B, 955H, 977K, 977L, 988, D6C, D6D, D6E, D6G, D6G2 LGP, D6G2 XL, D7G, D7G2
5M9567 SPOOL
572G, D6C, D6D, D6E, D6G2 LGP, D6G2 XL, D7G, D7G2
1P6596 SPOOL-SPEED SELECTOR
572G, D6C, D6D, D6E, D6G2 LGP, D6G2 XL, D7G, D7G2
3P2767 SPOOL
55, 57, D10N, D10R, D6D, D7G
2P3639 SPOOL
55, D10N, D10R, D5B, D6D, D7G, D9N
2P3617 SPOOL
55, D10N, D10R, D5B, D6D, D7G, D9N
3P2767 SPOOL
55, 57, D10N, D10R, D6D, D7G
2P3617 SPOOL
55, D10N, D10R, D5B, D6D, D7G, D9N
2P3639 SPOOL
55, D10N, D10R, D5B, D6D, D7G, D9N
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.