SPOOL AS 6Y8048 - Caterpillar

Illustration 14 g01083031
Install stator (25) on the turbine in the converter housing.
Install the following items: bearing retainer (24) , thrust bearing (23) and thrust bearing race (22) .
Illustration 15 g01082648
Install hub (21) to converter impeller (18) .
Illustration 16 g01082646
Install pump drive gear (20) to converter impeller (18) .
Illustration 17 g01082644
Turn converter impeller (18) . Install eight bolts (19) .
Tighten eight bolts (19) to a torque of 105 14 N m (77 10 lb ft).
Illustration 18 g01082636
Place converter impeller (18) into position on the converter housing.
Install 24 bolts (17) . Tighten 24 bolts (17) to a torque of 60 7 N m (44 5 lb ft).
Illustration 19 g01082633
Use Tooling (C) and a suitable press to install bearing (15) .
Illustration 20 g02354530
Use Tooling (C) and a suitable press to install seal carrier (13) .
Install metal seal ring (14) .
Use Tooling (A) in order to install retaining ring (12) to the stator carrier.
Illustration 21 g02354529
Install inner bearing race (11) to output shaft (6) .
Illustration 22 g02354516
Install bearing (8) to output shaft (6) .
Install ring (10) to output shaft (6) .
Use Tooling (A) in order to install retainer ring (9) .
Install the two O-ring seals to output shaft (6) .
Lower the temperature of bearing (8) on output shaft (6) .
Illustration 23 g02354536
Install output shaft (6) to stator carrier (7) .
Illustration 24 g02354537
Install output shaft (6) and stator carrier (7) to the center of the torque converter assembly.
Illustration 25 g02354520
Install washer (5) .
Illustration 26 g02354522
Install retainer (4) and three bolts (3) .
Tighten three bolts (3) to a torque of 30 5 N m (22 4 lb ft).
Illustration 27 g02354528
Install cover (2) and six bolts (1) .
Tighten six bolts (1) to a torque of 60 7 N m (44 5 lb ft).End By: Connect the torque converter to the torque converter updrive gears housing. Refer to Disassembly and Assembly, "Torque Converter Updrive Gears - Assemble".