SPOOL 7T6740 - Caterpillar

Removal Procedure
Start By:
Remove the main control valve and the mounting plate. Refer to Disassembly and Assembly, "Main Control Valve and Mounting Plate (Lift and Auxiliary) - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00339039
Typical Example
Place the plate assembly on wood blocks, as shown.
Illustration 2 g00495632
Remove tube assemblies (1), (2), (3), and (5) .
Disconnect harness connector (6) .
Remove two bolts (4) and pilot diverter solenoid valve (7) .Installation Procedure
Illustration 3 g00495632
Install pilot diverter solenoid valve (7) and two bolts (4) .
Connect harness connector (6) .
Install tube assemblies (5), (3), (2), and (1) .End By: Install the main control valve and the mounting plate. Refer to Disassembly and Assembly, "Main Control Valve and Mounting Plate (Lift and Auxiliary) - Install".